Hey Guys,
Many people told me this was the best way to go so I did. I have got hold of most parts to convert the rangie over to the Quadrajet. Just have to chase up a few small parts from the wreckers. Any got tips, info, photos, step by step guide on how to install and setup this thing.
Regards Kris
Edit/Delete Message
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Quadrajet installation
Moderator: Micka
When I get to my other computer tomorrow I can send some pictures. It is an easy job however I remember a bit of mucking around with accelerator cable, my car was ex efi and the cable was too short so Used a Speco one and cut the accelerator peddle end off and soldered on the Rangie end as the Speco one would not fit.
Ian
hmm,
dont seem to be able to find them. Must have deleted the photos, sorry.
Ian
hmm,
dont seem to be able to find them. Must have deleted the photos, sorry.
www.amtra.com.au
Who is online
Users browsing this forum: No registered users and 0 guests