Panel beaters in brisvegas

[basketcase]

Does any one in the brisbane area know of a decent panel beater. Want to get the rear guards cut to fit the 34's under the 4runner.
Gone to a couple round the bowen hills area and they don't want to touch it or want to charge a $400 a side to do it.
Preferably near bowen hills or mount gravatt area. And one that maybe works on 4wd's.

[cbr]

Does any one in the brisbane area know of a decent panel beater. Want to get the rear guards cut to fit the 34's under the 4runner.
Gone to a couple round the bowen hills area and they don't want to touch it or want to charge a $400 a side to do it.
Preferably near bowen hills or mount gravatt area. And one that maybe works on 4wd's.

IMO that is not really a bad price. I did get mine for alot less (but I got a good deal). Remeber they need to re-make the inner fender.

I had the same response. I got a quote for $5000 to get the front and rear done. I did not get it done at that place

You would be better off getting a 4wd mod place to do the job as they don't question the reason for doing it, like most other places.

Chris.

[chimpboy]

PM'd you.

[-Mick-]

Try Pine City Smash on the norfside mate

They don't mind little jobs, they're doin some rust in my spook for around $300. That's a good $100-150 cheaper than I could get elsehwere.

My mechanic recommended em to me. PM me if you want their no.

[-Scott-]

You could try Silver Star out at Wynnum. Until recently he had quite a nice black Wrangler, and doesn't mind the occasional different job.

Scott

[basketcase]

Thanks for that guys. Pine Rivers and Wynnum are a tad far with work and TAFE. Might go check them out if nothing works out in my area.