Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Rim compatability .

General Tech Talk

Moderators: toaddog, TWISTY, V8Patrol, Moderators

Forum rules
Post Reply
Posts: 3443
Joined: Tue Oct 29, 2002 10:50 pm
Location: Currently On the Road !!

Rim compatability .

Post by Dozoor »

Just wondering , After a set of 16" rims for Gq nissan patern .

16x7 ,16x8 --

which rims are of the same stud patern, More offset would be good but not a real important ,

80 series ? More offset or less ?
Top
Posts: 3523
Joined: Sun May 18, 2003 8:42 pm
Location: Somewhere they can't reach me, shoot me or electrocute me...

Post by Area54 »

The 75 Series rim has the largest offset of any production rim off the shelf in an eight inch width.
Built, not bought.
Top
Posts: 3443
Joined: Tue Oct 29, 2002 10:50 pm
Location: Currently On the Road !!

Post by Dozoor »

These are 16s -54 ,
Top
Posts: 1508
Joined: Thu Jun 26, 2003 9:48 am

Post by MQ080 »

Dozoor wrote:These are 16s -54 ,


-54 offset?!?!

I think the largest avaliable before custom is a -44 on a 15x10

toyotas also run a lower offset (stick out further) than nissans, except for IFS models
Top
Posts: 3523
Joined: Sun May 18, 2003 8:42 pm
Location: Somewhere they can't reach me, shoot me or electrocute me...

Post by Area54 »

Dozoor wrote:These are 16s


You can get 16 inch rims for the 7# series cruisers, and they have the same 6 stud by 5.5inch pattern. This is the largest offset (wider track) rim you can buy off the shelf in a mass produced 8 inch rim.
Built, not bought.
Top
Posts: 3443
Joined: Tue Oct 29, 2002 10:50 pm
Location: Currently On the Road !!

Post by Dozoor »

Mq referering to Area 54

Thanks 54.
Top
Posts: 114
Joined: Fri Aug 08, 2003 2:28 pm
Location: Far Nth Coast NSW

Post by blu125 »

Watch centre bore sizing - TLC 108mm - NisPat 110mm
Top
Post Reply

Return to “General Tech”

Who is online

Users browsing this forum: No registered users and 4 guests