Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
"poly air" air bag spacers???
Moderators: toaddog, TWISTY, V8Patrol, Moderators
"poly air" air bag spacers???
hi. i bought my gq with rear poly air air bags and then lifted it 3 inches so now i need some 3 inch spacers and tjm and arb dont staok any thick enough. they oly go to 50 mm so does any one have any ideas on where to buy some or have any other solutions to other materials that could be used. cheers
Soccer, Cricket and Footy all require 1 ball to play. My sport requires 2!!!!
95 GQ,lift,33's,IPF's,exhaust,4400,dual batts,Engel,custom sliders,drawers,snorkel.
95 GQ,lift,33's,IPF's,exhaust,4400,dual batts,Engel,custom sliders,drawers,snorkel.
It might not hurt to talk to the Air Bag Man - http://www.airbagman.com.au/
This is not legal advice.
I had this very same problem when i put poly airs into my GU with a 3 inch lift.
They supplied to small poxy spacers that moved out of position everytime my spring flexed down.
I went to a plastic supplier and they machined up two 3 inch spacers out of poly ethelene and to the inside diameter of the coil, the poly airs sat nicely on the top.
I had a 10mm clearence hole drilled through the spacers, then i counter boared down the dept of the bolt head then i droped a 3.5 inch bolt through and bolted them down through the hole in the bottem spring retainer
Was a cheap and perfect fix.
Grant.
They supplied to small poxy spacers that moved out of position everytime my spring flexed down.
I went to a plastic supplier and they machined up two 3 inch spacers out of poly ethelene and to the inside diameter of the coil, the poly airs sat nicely on the top.
I had a 10mm clearence hole drilled through the spacers, then i counter boared down the dept of the bolt head then i droped a 3.5 inch bolt through and bolted them down through the hole in the bottem spring retainer
Was a cheap and perfect fix.
Grant.
GU III TD42T UFI18G Cross Country IC, 20 PSI. Neeeeeed mooooore Fueeeeeel.
Who is online
Users browsing this forum: No registered users and 2 guests