Shortening a 9 inch Brisbane

Post by **sloshy** » Thu Apr 23, 2009 8:19 pm

Who does this around brizzy?
I will need my axles resplined as well.
What sort of coin is it worth?

Post by **ISUZUROVER** » Thu Apr 23, 2009 8:29 pm

buds4x4?

Post by **berad** » Sun Apr 26, 2009 1:44 am

http://www.superformance.com.au/

its at capalaba, a mate had a 9inch modified to fit a vk, and stronger axles machined up there, the new axles compared to standard are a level above the rest, beefed right up.

Theres also a place at brendale which does the same stuff but further away from you.

Any rod shop, or serious rotar race team/shop will be worth a ring for a quote.

Post by **nastytroll** » Sun Apr 26, 2009 8:31 am

there was a place down the gold coast my bro used years ago too.

Post by **nottie** » Sun Apr 26, 2009 10:35 am

http://www.qpaac.com.au/index.php
Queensland performance axels and components

Post by **CRUSHU** » Mon Apr 27, 2009 11:33 am

Cut down & Resplined axles are weaker than stock axles, as the hardening isn't replaced.
Aftermarket alloy axles will be $600 - $900 depending on quality, complete.

My guy charges $350 to shorten the housing.

Post by **sloshy** » Mon Apr 27, 2009 9:23 pm

Just need the housing shortened now I am getting some after market axles, don't know what brand yet though, any recommendations?

Post by **CRUSHU** » Mon Apr 27, 2009 9:53 pm

Moser are the best, from Supa Trik engineering in Melbourne. Good warranty too. It is a replacement warranty, of the next size up. He can shorten your housing too.

Post by **sloshy** » Mon Apr 27, 2009 10:23 pm

Was leaning towards moser axles, a few mates run them in 11 sec cars with no dramas.

Post by **I.M.P.O.S.E** » Tue Apr 28, 2009 12:16 am

How short are you looking to go with the housing?

Post by **sloshy** » Tue Apr 28, 2009 4:54 pm

I.M.P.O.S.E wrote:How short are you looking to go with the housing?

40mm a side.

Outer Limits 4x4 Board

Shortening a 9 inch Brisbane

Shortening a 9 inch Brisbane

Who is online