Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Gq overheating problems. help needed

Tech Talk for Nissan owners.

Moderators: toaddog, V8Patrol

Post Reply
Posts: 9
Joined: Tue Oct 14, 2008 9:47 pm
Location: Tuggerah NSW Gosford

Gq overheating problems. help needed

Post by db1891 »

Fully rebuilt TD42 Turbo in my GQ new head radiator waterpump etc etc. I have a bonnet scoop every thing brand new
Had twin thurmo fans car ran hot above 110km on 40 deg day on a trip had to run at 100kmotherwise temp gauge in the red.
put the original fan assembly back on new fan blade and viscus hub and shielding car ran cooler but got to same temp about 10kms higher. so original fan system better than twin thurmo fans.
I fitted a piece of rubber underneath the car to help with air flow back to the front diff didnt seam to make any difference.
Somebody stated that there is a modified waterpump to slow the water going around the motor and they then run cooler. if so where do i get one from. any other suggestions I can do. Viscous hub is tight and has heabs of silicon in it.
Posts: 62
Joined: Sat Jul 05, 2008 6:21 pm
Location: south-west of the north-east frontier

Post by patrolla »

have you been through any bog holes, ever? perhaps remove the radiator, hold a light behind it and see if you can see through it. a hose out might fix it.
gq with stuff
Posts: 1258
Joined: Wed Mar 21, 2007 7:49 pm
Location: Mornington/ Victoria

Post by PGS 4WD »

Most Thermos shoud be turned off above 100 kph, the air flow from the road speed is actually greater and the fans can slow the air through the radiator. Get the radiator out and to a competant shop to do a proper flush, remove a tank and push the capilliaries clean, it is common for the TD42 to block the radiator partially with scale as they are a cast iron block and head.

Joel
-Pre trip inspections/ servicing
-Suspension/ custom modifications
-4wd Dyno & tuning
-Qualified mechanics
Posts: 105
Joined: Sun Nov 18, 2007 7:12 pm
Location: Dont no

Post by msjc38 »

How new is engine? Alot of times a new engine will run hot if it has been built a bit tight. It might just need a bit more running in. If you have used a non genuine water pump check water pump cavitation. Also check for air locks,thermostat could be faulty or wrong application use a genuine one. Is it over fueling get it on a dyno check egts they could be too high
Posts: 171
Joined: Wed Jul 30, 2008 7:26 am
Location: Gold Coast

Post by DanwinGQ »

I had temp problems with mine when I first got it.
Fitted a new 4 core radiator, New viscous hub fan, high flow thermastat. After fitting some new injecters, fitting a turbo and getting a proper tune I cant even get a quarter out of factory temp guage. Even with aircon cranking towing my camper. Try new thermastat.
Thirsty GU. TI, 4", 33's, factory locker.
Posts: 9
Joined: Fri Mar 09, 2007 4:58 pm

Post by blackops »

could be something as simple as the bottom radiator hose distortin under revs due to a bodylift oversight,radiator position could be enough to distort the hose or flow if u have new pump check the impelers flowing the right way?
Posts: 252
Joined: Fri Sep 02, 2005 3:45 pm
Location: outside your window

Post by hiy6o »

Use a Genuine clutch fan hub and thermostat make sure the radiators cleaned out .
Nup not telling
you'll have to find out yourself
Post Reply

Who is online

Users browsing this forum: No registered users and 44 guests