Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

HD-E Engine Timing

Tech Talk for Ford, Mazda, Daihatsu & Makes that currently dont have a home.

Moderator: Tiny

Forum rules
Post Reply
Posts: 137
Joined: Tue Jun 03, 2008 6:18 pm
Location: Sydney, Australia

HD-E Engine Timing

Post by McLarryBob »

hey just wondering what the factory specs for the ignition timing on this feroza engine

Thanks
Top
Posts: 2297
Joined: Mon Mar 06, 2006 1:23 pm
Location: Melbourne-Australia

Post by MightyMouse »

download ignition section ( or better still whole manual ) from www.warfs.org

has the complete go to whoa procedure.
( usual disclaimers )

It seemed like a much better idea when I started it than it does now.
Top
Posts: 14187
Joined: Wed Apr 30, 2003 8:09 pm
Location: Trip Trip Trappin' across a bridge

Contact:
Contact Goatse.AJ

Post by Goatse.AJ »

I'd tend to knock a little of what the manual recommends for timing, OR always run at least 95RON fuel. Otherwise most Feroza donks ping their titties off and will eventually die.
bru21 wrote:What happens in goat, stays in goat!
Top
Posts: 212
Joined: Sun Nov 02, 2008 10:53 pm
Location: Sydney

Post by chugga »

My engine lasted 220,000 km and still going and it doesnt knock. The only time it pingd is when i advance it to get abit of grunt.
Top
Posts: 2297
Joined: Mon Mar 06, 2006 1:23 pm
Location: Melbourne-Australia

Post by MightyMouse »

AJ's got a good point. I usually fine tune by ear when I'm driving. If it pings when worked hard a bit more retard.

As virtually nothing on/in the engine is standard the actuall figures aren't much use to anyone however.
( usual disclaimers )

It seemed like a much better idea when I started it than it does now.
Top
Posts: 137
Joined: Tue Jun 03, 2008 6:18 pm
Location: Sydney, Australia

Post by McLarryBob »

just looked at the manual and it dosent have an acual degree setting it just says check to see that the mark on the crankshaft pulley is aligned with the indicator of the timing belt cover...

i suppose that will have to do, ill have a bit of a play with it though

Thanks guys
Top
Posts: 4760
Joined: Mon Dec 30, 2002 6:04 am
Location: Adelaide

Contact:
Contact murcod

Post by murcod »

3 degrees advanced (+- 2) rings a bell.

I could never run mine on even the "factory" 3 degrees due to pinging. Even using 98 octane fuel.
David
Top
Post Reply

Return to “Ford / Mazda / Daihatsu / Homeless”

Who is online

Users browsing this forum: No registered users and 7 guests