Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

way too much toe out

Tech Talk for Mitsubishi owners.

Moderator: -Scott-

Post Reply
Posts: 4
Joined: Wed Apr 01, 2009 1:09 pm
Location: Newy

way too much toe out

Post by TomPajjy »

hi, I have a nf swb pajero. I went for a bit of a 4b this afternoon (mainly mud and deep puddles) and somehow I have bent something as now my tires are both pointing out a lot. I am going to put it up on the hoist and have a look, but if anyone has any advice on what to look for or how to fix it, I would greatly appreciate it. Thanks

Tom
Posts: 18
Joined: Thu Dec 18, 2008 6:54 pm
Location: Cairns,NQ

Post by SiKnEsS »

id be checking ur castor of the front wheels, u may have bent a lower or upper control arm back and in a bit causing the hweels to kick out at the front, other than that im stumped, unless ur tie-rod end has stripped a bit of thread,
Posts: 4
Joined: Wed Apr 01, 2009 1:09 pm
Location: Newy

Post by TomPajjy »

yeah mate my upper control arm might be a little bit bent on the passenger side, but nothing heaps noticeable. not sure yet. but the toe out is bad, like i cant go over 40k's without my tires squealing heaps bad. haha. thread looks sweet on my tie rod ends, good idea though
Posts: 860
Joined: Sat Mar 07, 2009 1:14 pm
Location: Newcastle

Post by ethann »

I'm actually in the same boat right now.
Same thing has happened to me. Haven't really had time to look hey haha.

My alt is playing up, Or something is cause it's not recharging -_-. So i'll be looking at that first.
Team Lock n load.
www.facebook.com/locknloadaustralia
Posts: 4
Joined: Wed Apr 01, 2009 1:09 pm
Location: Newy

Post by TomPajjy »

It looks like the uprights are bent? but I had enough thread on my out tie rod ends to wind the toe in enough (just, haha). Yeah ive been through an alternator and now my stater motor has shit itself, haha i have to stop going through the deep puddles!
Posts: 18
Joined: Thu Dec 18, 2008 6:54 pm
Location: Cairns,NQ

Post by SiKnEsS »

yer, my starter is a bit on the noisy side after loosing my gearbox inspection plate while in mushy clay, also caked the bell housing full of mud so my throwout bearing wouldnt let the clutch disengage, was like keeping ur foot on the clutch pedal lol, so i think il sikaflex the bastard on this time haha, and il lube up the starter again
Posts: 75
Joined: Fri Mar 20, 2009 3:11 pm
Location: Adelaide

Post by steverisingsun »

The drag link that goes from left to right bends in towards the diff. Check him out.
Steve
Posts: 18
Joined: Thu Dec 18, 2008 6:54 pm
Location: Cairns,NQ

Post by SiKnEsS »

then that would cause tow in, not tow out wouldnt it?
Post Reply

Who is online

Users browsing this forum: No registered users and 11 guests