drop boxes for an 80

[Coogs]

Tried the search function to no avail
Can someone tell me if anyone produces them????
There was a set for sale not long ago from memory but couldn't find that ad either?
If anyone knows anything it would be a breat help....

[RV80]

They are available. But are not worth it, they hang to far below the chassis IMO you are better of with dropped arms.

[Jeff80]

Coogs, I looked into it a while ago and there was someone on here who makes them, in QLD or NSW from memory.
I ended up going the castor plates as 1) Dropped arms a way too expensive ($1200 give or take) and 2) drop boxes were pretty hard to find and hung down way too low for my liking. I figure if I stuff the castor plates, I'll take it to AUS4WD or similar to get the diff rolled proffesionally.

I'll look back and see if I can fins anything on the drop boxes. Stay tuned...

EDIT - Found: http://www.outerlimits4x4.com/ftopic141 ... ight=boxes

Might want to give ASSASIN OFFROAD a call. They may do them also. (they are located in Geelong somewhere)

Jeff

[RV80]

Here you go http://manafreaus.cart.net.au/details/2509287.html

[STUMPY]

i found these
http://cgi.ebay.com.au/Toyota-Landcruis ... 1|294%3A50

[Jeff80]

Here you go http://manafreaus.cart.net.au/details/2509287.html

RV, I tried to contact them twice via email while I was looking, and they didn't reply.

Jeff

[RV80]

Here you go http://manafreaus.cart.net.au/details/2509287.html

RV, I tried to contact them twice via email while I was looking, and they didn't reply.

Jeff

Try http://www.man-a-fre.com/ in the US

[bowtie landie]

Use drop arms for any lift over 4" - if you use castor plates then the tie rod will foul the factory control arms. Drop arms are shaped so that they clear the tie rod even on full lock - whilst correcting castor.

Peter K.

[giantracing]

full bolt in drop box for 80 series, $395.........

[LOCKEE]

You putting in more lift?

[Coogs]

No way, I wouldnt be able to drive it as fast if i went too high
Just wouldn't mind getting a little caster... back
Don't want to do caster plates or drop arms

[killalux]

They are available, http://manafreaus.cart.net.au/cat/2041942.html

These are from AUS, and are the best drop boxes i have seen because they don't just use the single bolt to hold them in, They also brace back to the crossmember bolts, And only $380.

Steve

[bowtie landie]

They are available, http://manafreaus.cart.net.au/cat/2041942.html

These are from AUS, and are the best drop boxes i have seen because they don't just use the single bolt to hold them in, They also brace back to the crossmember bolts, And only $380.

Steve

They look good, I have seen other makes but these seem to be better engineered.