but i want to know whether it would pass CAMS inspections and whether id need to put some more supports to the chassis from the roll bar...and any other modifications
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
tray suited for competition use?
Moderators: toaddog, TWISTY, V8Patrol, Moderators
tray suited for competition use?
hey guys im looking into buying this tray:
but i want to know whether it would pass CAMS inspections and whether id need to put some more supports to the chassis from the roll bar...and any other modifications
but i want to know whether it would pass CAMS inspections and whether id need to put some more supports to the chassis from the roll bar...and any other modifications
Northside Fleet Services PTY. LTD.
243 Dundas Street Preston, Victora
(03)94840432
(For all your Gas and Mechanical needs)
243 Dundas Street Preston, Victora
(03)94840432
(For all your Gas and Mechanical needs)
http://www.ccda4wd.com.au/images/CCDAFW ... ion9.0.pdf
Nope.
Page 36
Nope.
Page 36
All tubing used in roll bar protection structures shall be circular section cold drawn steel tube (CDS, CDW or CEW) with properties shown in the following tables.
'89 Hilux Single Cab - 3RZ, 35" Kreepy Krawlers, 4.88's, F & R Air lockers, RUF, Longfields, TG Highsteer, Highmount and no money
Any questions with regards to Offroad racing CAMS rules, the rulebook can be downloaded from the site. Otherwise you can call Morrie Williams 0412 361 864 who is the tech inspector for offroad nationally. He will be able to sort out any questions. Good luck with your project.
http://www.dirtcomp.com.au/
CCDA/CAMS aren't going to care if you're only just bolting the cage through it - the cage will be the important/expensive bit.
Get stuck into the rulebook mate.
If you can/have to pay to get a proper cage built the tray is the simple bit.
Steve.
Get stuck into the rulebook mate.
If you can/have to pay to get a proper cage built the tray is the simple bit.
Steve.
[quote="greg"] some say he is a man without happy dreams, or that he sees silver linings on clouds and wonders why they are not platinum... all we know, is he's called the stevie.[/quote]
For sure, why not just make one yourself, one you like?collins110 wrote:well would i be able to use this as a base and just cut the bar off and get another one made?
It isn't hard, you can make it to suit your car, as its an older model one yeah?
'89 Hilux Single Cab - 3RZ, 35" Kreepy Krawlers, 4.88's, F & R Air lockers, RUF, Longfields, TG Highsteer, Highmount and no money
Who is online
Users browsing this forum: No registered users and 2 guests