Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Anderson plugs

General Tech Talk

Moderators: toaddog, TWISTY, V8Patrol, Moderators

Post Reply
Posts: 421
Joined: Fri Dec 05, 2003 12:35 pm
Location: Tweed coast

Anderson plugs

Post by 98lux »

Can you get an Anderson plug double adaptor.

I need 2 outlets at the back 1 for the Engel and 1 for the camper.
I was hoping i did not have to cut and splice the wires that are there
if ya gona rev it, Chev it
Posts: 522
Joined: Sat Jan 29, 2005 7:40 am
Location: Melbourne, Vic

Re: Anderson plugs

Post by Toy80Diesel »

98lux wrote:Can you get an Anderson plug double adaptor.

I need 2 outlets at the back 1 for the Engel and 1 for the camper.
I was hoping i did not have to cut and splice the wires that are there
If you don't want to touch the existing wires there, you could buy three anderson plugs and make up a double adapter of your own. It would be quite a short piece so going down a size in wire to fit double wires into one plug shouldn't be a problem.
Shut Up, Get Out, & Start Digging...
Posts: 45681
Joined: Wed Nov 27, 2002 10:13 am

Re: Anderson plugs

Post by bogged »

why not run another wire down the back?
Posts: 550
Joined: Tue Mar 04, 2008 7:40 pm
Location: Gympie Qld

Re: Anderson plugs

Post by fester2au »

bogged wrote:why not run another wire down the back?
Thsi would be the least dodgy approach. Given you are using Anderson plugs to begin with one would assume you are chasing maximum current for your chosen use at that distance so to then split it in 2 defeats the benefit of the set up to a degree. I would run 2 dedicated wiring runs and conectors. You can get a red anderson plug too in the same size if you want to ensure they never get cross connected if that's an issue.
Posts: 3523
Joined: Fri Aug 27, 2004 12:27 am
Location: Fairfield,Sydney

Post by pongo »

doesnt an engel only pull 2-3 amps. for a trailer you can run through a trailer plug or for a car run it through a ciggy lighter for flexability
Posts: 421
Joined: Fri Dec 05, 2003 12:35 pm
Location: Tweed coast

Re: Anderson plugs

Post by 98lux »

bogged wrote:why not run another wire down the back?
So you would run anouther 6B&S (13.5mm2) cable from the 2nd battery??
if ya gona rev it, Chev it
Posts: 421
Joined: Fri Dec 05, 2003 12:35 pm
Location: Tweed coast

Post by 98lux »

pongo wrote:doesnt an engel only pull 2-3 amps. for a trailer you can run through a trailer plug or for a car run it through a ciggy lighter for flexability
That is why i am running Anderson plugs as is melted the standard 6 pin round plug last time (but still worked :shock: )
if ya gona rev it, Chev it
User avatar
ddr
Posts: 589
Joined: Thu Jan 09, 2003 7:44 am
Location: Not where I wanna be

Post by ddr »

Thought about changing to one of the 12 pin plugs, they have some larger than normal plugs for higher loads.
Posts: 550
Joined: Tue Mar 04, 2008 7:40 pm
Location: Gympie Qld

Post by fester2au »

I would stick with running 2 seperate circuits right from the battery. That way if one fails the other is still available so you only loose one system.

Also an engel that's just cruising does only draw about 2-3 amps but can draw more when under heavy load. Also it's not about the amperage only it's more about getting a full 12 volts to everything you want to have 12 volts with. Sharing off the one line may compromise that.

I remember in some of Engels instructions they also prefer you don't piggy back off the fridge power feed for anything else either.

You don't say what sort of load you are using in the camper.

For the cost of a bit of wire and a couple of connectors I have 1 circuit inside the wagon for the Engel, another inside for a camp light and a third to the towbar dedicated to the van for charging and topping up the batteries whilst running the 3 way fridge on 12 volt while travelling.

Don't ever bother running anything decent off the cig lighter in the car unless you upgrade that wiring circuit and preferrably toss the cheap arse cig plug the manufacturer likely used and putting a good aftermarket one in. Car cig lighters are good for running your navman or the kids portable dvd or charging your mobile and that's about it.
Posts: 45681
Joined: Wed Nov 27, 2002 10:13 am

Post by bogged »

fester2au wrote:I would stick with running 2 seperate circuits right from the battery. That way if one fails the other is still available so you only loose one system.

Also an engel that's just cruising does only draw about 2-3 amps but can draw more when under heavy load. Also it's not about the amperage only it's more about getting a full 12 volts to everything you want to have 12 volts with. Sharing off the one line may compromise that.

I remember in some of Engels instructions they also prefer you don't piggy back off the fridge power feed for anything else either.

You don't say what sort of load you are using in the camper.

For the cost of a bit of wire and a couple of connectors I have 1 circuit inside the wagon for the Engel, another inside for a camp light and a third to the towbar dedicated to the van for charging and topping up the batteries whilst running the 3 way fridge on 12 volt while travelling.

Don't ever bother running anything decent off the cig lighter in the car unless you upgrade that wiring circuit and preferrably toss the cheap arse cig plug the manufacturer likely used and putting a good aftermarket one in. Car cig lighters are good for running your navman or the kids portable dvd or charging your mobile and that's about it.
what he said.. fwiw, yes I'd run a second one.
Posts: 2590
Joined: Tue Jan 04, 2005 11:33 am
Location: Brisbane

Post by Chucky »

Onteh input of the first anderson plug (Car side) just parralle off this to a second plug.
Seen this done before for a similar setup and never heard of any bad outcomes.
Post Reply

Who is online

Users browsing this forum: No registered users and 109 guests