Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Auto electrical work????

For all things Electrical.

Moderator: -Scott-

Post Reply
Posts: 36
Joined: Mon Mar 30, 2009 9:11 am
Location: Nelson Bay

Auto electrical work????

Post by scarman »

Hi all,
I am thinking of having some electrical work done to my Diesel Zuk.
The reason for this is the amount of spare wires and minor electrical problem i have been having :cry: . I also want more room in the engine bay to make life easyer in the long run. I would do the work myself but i am traveling and want my zuk to be tip top when i get back and just drive it.
I want to move most or all of the electrical stuff moved to behind the front seats in a box.
I want a dual battery set up with a monitering system and kill switch installed. In the same area i want the fuses and realys for simple problem shooting when needed.
I will probley be having the work done in the Newie or hunter valley and is there any places that anyone has used and came recomend.
Can any one tell me a ball park figure for this work to be done. Would be apperciated so i know a ruff figure , for when talking to shops. I dont mnd paying more for good work.
Also will i need to tell them to soilder the work or do you think that crimping is better. I have had a few problems in the past.
Cheers
Mick
Posts: 1208
Joined: Fri Nov 08, 2002 8:21 pm
Location: sunshine coast

Post by killalux »

Hey mate,
I specialise in doing this type of work. Without seing the car its hard to say but would prob recomend a full re-wire on the vehicle this will allow all the fuses an relay's to be mounted where you want them. (this is what i do on comp trucks and race cars)
If crimping is done with the correct tools and correct size terminals there should be no need to solder. Infact i recall reading in one of the catalogues (quikcrimp i think) That they advise not soldering as this can make the joint more prone to failure.
However any wires to be joined or spliced should be soldered.

Ballpark i would think around the $1500 to $2000 mark to do the job properly (ncluding dual battery controller, etc)

However I m on the sunshine coast, QLD. so may be a bit to far away for you.
Steve
KILLA KUSTOM KABLES
CUSTOM AUTO ELECTRICAL SPECIALISTS
0404811498
LS1 & DURAMAX ENGINE CONVERSIONS, DRIVE IN DRIVE OUT. PATROLS AND CRUISERS

LS1 STANDALONE HARNESS $475ex
Posts: 36
Joined: Mon Mar 30, 2009 9:11 am
Location: Nelson Bay

Post by scarman »

Thanks Steve,
Thats about what i expected, I am want to set the zuk up to have fun and latter do comps. Thanks for the reply, gives me some think to work with.
Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest