Replacing a cable end

Post by **dank** » Sat Jun 13, 2009 10:13 pm

Anyone know where these screw on cable ends are readily available?

have to replace an end on the kickdown cable on my auto. Its an odyssey cable knarp for bmx stuff. Are there auto versions ?

Post by **dank** » Thu Jun 18, 2009 9:30 pm

bump

Post by **pongo** » Thu Jun 18, 2009 9:34 pm

does it have to be that type?

Chase up the old pushy brake caliper that the cable goes through the hole and clamps down.

Or will a pop rivet with the nail knocked out of it and then crimped on hold it.

ring an auto tranny joint and ask em, failing that go to a decent pushy shop.

Let us know when you find a solution

Post by **YB.LOW4** » Thu Jun 18, 2009 11:34 pm

go to your nearest electrical wholesaler and ask what their smallest line tap is. I have never seen one that small but never know may get lucky.

Post by **Jaffa** » Thu Jun 18, 2009 11:50 pm

I made one out of a cut up suspension arm from a RC car, already had the tread cut in it and just used 2 grub screws to clamp it to the cable.

Outer Limits 4x4 Board

Replacing a cable end

Replacing a cable end

Who is online