just to clarify, I've checked it over and there its not possible to get a direct power to ground connection unless you wire up the relays incorrectly.
Simply trace the earth wires back on the diagram and you will see its not possible to hit power without going through a fan first.
When I first saw the diagram this was a concern of mine but after checking it over it was all good.
If the third relay stuck on, fan M1 would always be on high, if low speed was selected, M1 would remain on high while M2 would not come on at all, if on full speed setting both fans would operate as normal. Not such a bad outcome.
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Custom thermo fan and dual battery controller
Moderator: -Scott-
Yes, I apologise I was tired as I had been in Sydney all day and made a bad call there.stuee wrote:just to clarify, I've checked it over and there its not possible to get a direct power to ground connection unless you wire up the relays incorrectly.
Simply trace the earth wires back on the diagram and you will see its not possible to hit power without going through a fan first.
When I first saw the diagram this was a concern of mine but after checking it over it was all good.
If the third relay stuck on, fan M1 would always be on high, if low speed was selected, M1 would remain on high while M2 would not come on at all, if on full speed setting both fans would operate as normal. Not such a bad outcome.
This is not legal advice.
Who is online
Users browsing this forum: No registered users and 0 guests