gday weiner yeh its the front and the back, i machined ten 50mm holes
on either side of 75x50x4mm thick rhs this is on the rear yesterday arvo
and just going to gusset from each corner of the crossmemeber to the chassis
either way holes or no holes i think its just going to be the same strength wise
kodie
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
crossmember
Moderators: toaddog, Elmo, DUDELUX
Who is online
Users browsing this forum: No registered users and 5 guests