Installed my lockright auto locker in the rear of my sierra today. (I bought vicelore's).
I had initially wanted to install it into the front, but whilst I had to replace the rear wheel bearings, i whacked it into the rear.
Took me (a novice at cars) about 8 hours to pull the axles, pull the diff, install locker, walk to mech to have bearings pulled and pressed, and refit everything, add diff oil, and bleed the brake lines etc.
Using the haynes service manual as a guide to pulling the axles and diff.
The diff disassembly and assembly was guided using the installation booklet provided by lockright.
Following the instructions in the lockright booklet was very easy, and I made sure to mark everything.
To double check the backlash I smeared the gears with grease and spun them repeatedly.
I used the grease as a marker to show the point of contact on the bevel gears. and compare that to the pre worn areas.
On the test run, first corner (U-turn) I found it locked up. After a bit of practice on corners, the click was barely audible and you could feel the faint click click click each time.
Just select the gear for the corner, and keep the throttle steady. click, click, click.
The car felt alot more rigid when driving in a straight line.
Cant wait to test it out off road.
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
rear auto locker
Thats good that you did them yourself, i opted for a diff guy too install them in the diff centres and i then put them back in the diff.
Mine click at different loudness levels depending on the the conditions like heat in the diff. They take a little getting use to, sometimes perfect speed and clutch combo's are need when doing low speed tight turns in carparks and the like, otherwise it gets a jerky pulse like a bunny hopping L-plater
Chop
Mine click at different loudness levels depending on the the conditions like heat in the diff. They take a little getting use to, sometimes perfect speed and clutch combo's are need when doing low speed tight turns in carparks and the like, otherwise it gets a jerky pulse like a bunny hopping L-plater
Chop
I THINK ICAN, I THINK I CAN!
So you did all the hard work, and then paid someone to do the easiest bit?
A few dry practice installs as soon as the box arrived (prior to cracking the diff open) to understand exactly how it all functions is all that is needed.
People think my car is broken when im in the carparks etc.. click, click, click hehhe
A few dry practice installs as soon as the box arrived (prior to cracking the diff open) to understand exactly how it all functions is all that is needed.
People think my car is broken when im in the carparks etc.. click, click, click hehhe
Who is online
Users browsing this forum: No registered users and 99 guests