The car's got a 1 inch body lift kit + 2 inch heightened springs;
- im about to cut the front wheel arch so my bfg m/t 31x10.5 r15 will fit.....
- as all the other pics on guard cutting were on sierras...(that i saw anyway)
- has anyone got pics of their work in a vitara?
- as a rough guide how much clearance should i be trying to ensure i get between the wheel arch & tyre once its cut>?
- oh yeah and what do ppl think about guard cutting affecting the structural integrity of the front end>? any thoughts?
Thanks in advance
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Fitting 31"s on a '92 lwb vitara
Its heaps different to a Sierra. Cutting the guards wont do anything to the structure, as the Vit has a setup like a normal car with the guards, I have cut guards on a Vit to fit 35", you could even unbolt them if you wanted
My 31" fit within the size of the guards so they dont need to be cut.
But as error said you will be better off with a hammer to the firewall section, that is where your problem will be.
My 31" fit within the size of the guards so they dont need to be cut.
But as error said you will be better off with a hammer to the firewall section, that is where your problem will be.
LWB Vit, Trail Slayer
i run 31x10.5 inch muddies on my 92 lwb al i have is 2 inch spring spacers
as the boys previously have stated youhave to cut a little away from the plastic bumper, also take a hammer to the firewall there is a seam that runs down just flatten it and a bit more should do you there, with the rear height was ok just width when the tyre would dissapear under the gard it scored the sidewall so you need to flatten the lip i just used a hammerand flattened it or you can get it rolled properly just depends how much money you wanna spend and how you want it to look good luck
as the boys previously have stated youhave to cut a little away from the plastic bumper, also take a hammer to the firewall there is a seam that runs down just flatten it and a bit more should do you there, with the rear height was ok just width when the tyre would dissapear under the gard it scored the sidewall so you need to flatten the lip i just used a hammerand flattened it or you can get it rolled properly just depends how much money you wanna spend and how you want it to look good luck
thanks guys....
i actually chickened out & swapped the tyres for 30's; meaning less guard modification plus also a bit easier on the gear ratios; but i will still have to bash the firewall in & maybe trim a bit of the front wheel arch at the rear.
next thing to do i guess is to whack on the tyres & see where it kisses; then let the american screwdriver do the rest.
ill let u know how it goes
Cheers
josh
i actually chickened out & swapped the tyres for 30's; meaning less guard modification plus also a bit easier on the gear ratios; but i will still have to bash the firewall in & maybe trim a bit of the front wheel arch at the rear.
next thing to do i guess is to whack on the tyres & see where it kisses; then let the american screwdriver do the rest.
ill let u know how it goes
Cheers
josh
Who is online
Users browsing this forum: No registered users and 15 guests