Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

engineer certificate

General Tech Talk

Moderators: toaddog, TWISTY, V8Patrol, Moderators

Forum rules
Post Reply
Posts: 1
Joined: Sun Jul 05, 2009 6:14 pm
Location: MUDGEE

engineer certificate

Post by cody walker »

hi i am almost finished my 75 landcruiser and i am looking for a engineer. it is sprung over and has a bodylift am looking for some one around newcastie or mudgee if any one can help out thank you.
Top
User avatar
DamTriton
God of Athiests
Posts: 8336
Joined: Thu Aug 07, 2003 2:14 am
Location: Brownsville

Post by DamTriton »

Probably should have done it the other way. Getting engineering advice before you start is the more logical and in the long run cheaper way of doing it. This question (Newy engineer) has been covered recently if you search...
George Carlin, an American Comedian said; "Think of how stupid the average person is, and realise that half of them are stupider than that".
Top
User avatar
DIRTY ROCK STAR
Im here for the sausage!
Posts: 15646
Joined: Wed Sep 24, 2003 7:11 pm
Location: NEWCASTLE

Post by DIRTY ROCK STAR »

save ya search, get on the RTA website search for sigantories.

athol on here is one.

there are only a couple of them in newy.
EVERYONE LOVES A 40
www.lovells.com.au
RAW4x4
Top
Posts: 335
Joined: Mon Oct 10, 2005 10:33 pm
Location: newcastle

Post by xenith »

talk to athol on here is in newcastle has done a fue of mine but yea should have seen him first need to legthen bump stops mud flaps 230mm off ground i think and so on
it will go or it will blow
Top
Post Reply

Return to “General Tech”

Who is online

Users browsing this forum: No registered users and 0 guests