Notice: We request that you don't just set up a new account at this time if you are a previous user. If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
I am going to redo my front wheel bearings on my Zuk on saturday, previously I have used the "she will be right mate" hammer and punch method ...
This time I want to do it by the book .. torque wrench etc.
What size socket will I be needing for the wheel bearings and what should the drag be on the bearing once its tight enuff ?? (from memory it was about 2kg)
The nissan diffs are comming, but are still a few months off as I think I will save for an airlocker as well so I may as well wheel what I got till it dies
" If governments are involved in the covering up the knowledge of aliens, Then they are doing a much better job of it than they do of everything else "
I think i have a wheel bearing socket in my toolbox at home. I'll have a look tonight and if so bring it to work. You can borrow it if you want, if i have one that is
" If governments are involved in the covering up the knowledge of aliens, Then they are doing a much better job of it than they do of everything else "
Thats quite alright .. thanks for looking .. will order one to pick up with my wheel bearings.
Managed to get bearing kits (koyo) etc for $40 a side .. repco quoted me $75 a side.. so I am still doing OK ..
" If governments are involved in the covering up the knowledge of aliens, Then they are doing a much better job of it than they do of everything else "
