NG swb Paj cutting out at the most inconveinient of times

Post by **opindown** » Sun Sep 20, 2009 8:21 am

Hey,
I have not long bought my self a swb ng paj with the 2.6l 4g54 carbied motor.
I have taken it out twice and both times i have been through tiny mud holes (less then a foot deep).
The paj is fine after goin through them, it isnt untill further on it the day (last time whilst goin up a steep rocky climb) it lost power.
when i say lost power, the paj pretty much just dies but wont stop completely (it will idle fine) it is just the higher revs it doesnt like for a minute or 2 then it will go back to being fine again.
Any help would be great.

Also can any one shead some light on how to water proof these engines to a certain degree? tips/tricks?

Thanks in advance

Post by **macneil** » Sun Sep 20, 2009 7:23 pm

it could be float level? if its on hills

Post by **opindown** » Mon Sep 21, 2009 5:06 pm

is trere any way of stopping that. this is my first carbied car, if it was injected it wouldnt be near as hard for me to figure out

Post by **bakerboy** » Mon Sep 21, 2009 6:40 pm

check this thread out on carbies mate http://www.outerlimits4x4.com/ftopic186736.php

Outer Limits 4x4 Board

NG swb Paj cutting out at the most inconveinient of times

NG swb Paj cutting out at the most inconveinient of times

Who is online