Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
winch problem need help
Moderators: toaddog, TWISTY, V8Patrol, Moderators
winch problem need help
i have a magnum 9k winch and the cable doesnt want to come out but it goes in fine. probably something simple but not sure where to start.
2000 gu ute, 3" exhaust, 35 MTZ's
solenoids??
try reversing the two wires on the motor that are side by side. after you reverse the wires and try run it, it should winch in when you move the hand control to out and vice versa.
if it winches out but not in after you have reversed the wires, the out circuit in you solenoids or control circuit is crook.
good luck.
try reversing the two wires on the motor that are side by side. after you reverse the wires and try run it, it should winch in when you move the hand control to out and vice versa.
if it winches out but not in after you have reversed the wires, the out circuit in you solenoids or control circuit is crook.
good luck.
Who is online
Users browsing this forum: No registered users and 1 guest