Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

MK Triton centre bearing replacement

Tech Talk for Mitsubishi owners.

Moderator: -Scott-

Forum rules
Post Reply
Posts: 1434
Joined: Sat May 22, 2004 6:44 pm
Location: stalking

MK Triton centre bearing replacement

Post by blackmav »

Got a flogged out centre bearing in the rear tailshaft of an MK Triton.
Is it a bearing that needs to be pressed on with a specialty/shop press or can it be done with an ordinary press?
Short GQ, Petrol, Turbo.
GQ TD42 ute
Top
Posts: 59
Joined: Tue Jan 02, 2007 9:14 pm
Location: redlands

Post by mowerman »

Mines been stuffed for the last 200,000ks.

Doesnt make any difference.


.
Top
Posts: 1434
Joined: Sat May 22, 2004 6:44 pm
Location: stalking

Post by blackmav »

mowerman wrote:Mines been stuffed for the last 200,000ks.

Doesnt make any difference.


.
It looks like the rubber flexy bit is gone.It shudders when you take off from a corner. Not much fun..
Short GQ, Petrol, Turbo.
GQ TD42 ute
Top
Posts: 59
Joined: Tue Jan 02, 2007 9:14 pm
Location: redlands

Post by mowerman »

Mine doesnt shudder.

Just thumps a bit going over reasonable bumps.

My mech of 30 years said he could replace it but probably have to do it again within 100.000ks.

You can get under vehicle and rattle the tailshaft around.

Seems to be inherent in the tritons.

.
Top
Post Reply

Return to “Mitsubishi”

Who is online

Users browsing this forum: No registered users and 12 guests