Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Body lift
Moderators: toaddog, Elmo, DUDELUX
Yep, I do.
Before you start putting in the blocks, get extended brake lines fitted, extend the steel lines in the engine bay(brakes and clutch) they are wound up in a coil- carefully unwind them, use hitensile bolts/nyloc nuts and the original bushes/washers/spacers for the blocks, you may need to extend the fuel filler hose as well.
Do the front, then the back then the ones in between, checking and rechecking everything while you go.
When alls done and fitted, check and recheck everything again, you may need to trim some of the fan shroud, if the fan hits, you may need to trim out around the gearstick/hilo range selector, but check first. If you have any trouble getting into 2nd gear or reverse, then trim. Same with the Hi-Lo selector.
If you have a bullbar, that will have to be raised to suit your body lift, easy as cut, weld in a piece, refit, but you will have to figure out where to cut and how much to weld in.
Thats about it.
Do a search using the function at the top of page, before you go. Theres more threads on this topic.
JUst go slowly and check/recheck everything as you go. Its a fairly easy mod to fit.
Good luck.
Before you start putting in the blocks, get extended brake lines fitted, extend the steel lines in the engine bay(brakes and clutch) they are wound up in a coil- carefully unwind them, use hitensile bolts/nyloc nuts and the original bushes/washers/spacers for the blocks, you may need to extend the fuel filler hose as well.
Do the front, then the back then the ones in between, checking and rechecking everything while you go.
When alls done and fitted, check and recheck everything again, you may need to trim some of the fan shroud, if the fan hits, you may need to trim out around the gearstick/hilo range selector, but check first. If you have any trouble getting into 2nd gear or reverse, then trim. Same with the Hi-Lo selector.
If you have a bullbar, that will have to be raised to suit your body lift, easy as cut, weld in a piece, refit, but you will have to figure out where to cut and how much to weld in.
Thats about it.
Do a search using the function at the top of page, before you go. Theres more threads on this topic.
JUst go slowly and check/recheck everything as you go. Its a fairly easy mod to fit.
Good luck.
MrsForby wrote: Oh I desperately truly love the taco.
Who is online
Users browsing this forum: No registered users and 2 guests