Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
reduction gears question
Moderators: toaddog, TWISTY, V8Patrol, Moderators
reduction gears question
I've bought a bundera with reduction grearing. It revs at about 3400 at 110km/h and i want to lower the rmp. I dont know what kit has been installed but is it likely that the high range can be returned to normal without chaning the low?
1986 2L-T Bundera
Bigger tyres.
Change diff ratios.
IIRC the gearing sets come with a fixed combination of ratios (ie high and low ratio geras cut from the same lump of metal) and you cannot simply change the high ratio only.
Change diff ratios.
IIRC the gearing sets come with a fixed combination of ratios (ie high and low ratio geras cut from the same lump of metal) and you cannot simply change the high ratio only.
George Carlin, an American Comedian said; "Think of how stupid the average person is, and realise that half of them are stupider than that".
its quite common in the hilux's for them to run 3100-3250 RPM with these motors and 31's....
If you have crawler gears then change the diff ratio's, you don't normally change high range when you put in crawler gears in bundies...
But the RPM isn't that far from normal... not that it makes it right
Best thing and easiest is to run bigger tyres if you have the room in the guards...
Brad
If you have crawler gears then change the diff ratio's, you don't normally change high range when you put in crawler gears in bundies...
But the RPM isn't that far from normal... not that it makes it right
Best thing and easiest is to run bigger tyres if you have the room in the guards...
Brad
3.0L turbo diesel, 4" lift, bud's front housing, track assasin cv's, air lokker front + Rear, beadlock'd 37 stickies, high steer, 15.5" travel ranchos, high pinion diff and coils on the rear
Re: reduction gears question
Reduction (rockhoppers) gears only affect low range.Syzygy wrote:I've bought a bundera with reduction grearing. It revs at about 3400 at 110km/h and i want to lower the rmp. I dont know what kit has been installed but is it likely that the high range can be returned to normal without chaning the low?
Changed Diff ratios will affect Low and High.
peak torque is closer to 2500 so its reving way to high IMHO.
my 3L lux revs at 3000 at 120 and this is perfect I feel. good torque to 120km and peak torque at 100km/h.
lift a wheel and spin it and count how many time it turns to one turn of your rear drive shaft. halve this and this gives your diff ratio.
chances are its 4.88 or higher.
my 3L lux revs at 3000 at 120 and this is perfect I feel. good torque to 120km and peak torque at 100km/h.
lift a wheel and spin it and count how many time it turns to one turn of your rear drive shaft. halve this and this gives your diff ratio.
chances are its 4.88 or higher.
*there's a rock, drive over it :) there's a bigger rock, drive over it :twisted: there's an even bigger rock, oops broke it :oops: Upgrade broken bit :bad-words:
Goto *
Goto *
Who is online
Users browsing this forum: No registered users and 0 guests