Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
noise in rear end
noise in rear end
hey all. i have just started to have a noise in the back end of my zook
i got a spoa and a welded rear. it makes a klunk noise sum times when turning, the lock still works, i did notice the to front bushes on the springs and skrewed could that be making the sound? plz help thanks
i got a spoa and a welded rear. it makes a klunk noise sum times when turning, the lock still works, i did notice the to front bushes on the springs and skrewed could that be making the sound? plz help thanks
pull the diff out and check it, it only takes 30 mins, if you give the welded are hard time it tends to screw axles pretty easy especially if driven on the road just pends how you drivezukimudman wrote: how do i know its not the diff centre cos i only just put the locka in and a new cluth dont want to much to tak apart again
gu ute 4"coils, amada xtremes, chopped chassis 450mm, 37" treps, rock sliders, internal cage, roof sliders, f&r air lockers, uhf, modified highmount winch, UFI turbo, km diesel inj pump.
my old welded rear use to make a ugly clunking sound on occasions once we pulled ikt apart we found that it had slipped on the welds in the spider gears, that was the noise i was hearing but it only ever happened a few times in about a year...
[quote="MissForby"]"I like Pillows. I'm not allowed anything hard" :D[/quote]
94 vitara, rear air locker, 31's, dual battery, custom front and rear tube bars, chopped guards, reduction gears
94 vitara, rear air locker, 31's, dual battery, custom front and rear tube bars, chopped guards, reduction gears
That sounds like a wheel bearing. I had the same happen just recently.mudbogga wrote:ok mine is doing the same i was in the bush started clunking everynow and again from the rear wheel drove home when i pulled off the moterway and slowed down realised it was MUCH MUCH worse pulled up at home there is diff oil dribbeling out the drivers side wheel
[quote="STD CONSUMER"]haha, i'm tellin you, my camp was hard to find on Saturday night!
then i shared my bed with 2 second tom... [/quote]
then i shared my bed with 2 second tom... [/quote]
yep you are on the money
got back out to the friends place where i left my sierra pulled the rear axil and the drivers bearing was in lots of pieces passenger side is not so flash either
4wd products on eBay has a replacement set for $85
now upon reading forums i gather i need a hydraulic press to install bearings but a grinder and a chisel will get them off
figured i could buy the bearings remove the old ones and take the axils into a shop to have them pressed
trying to save a buck
any advice would be much appreciated
got back out to the friends place where i left my sierra pulled the rear axil and the drivers bearing was in lots of pieces passenger side is not so flash either
4wd products on eBay has a replacement set for $85
now upon reading forums i gather i need a hydraulic press to install bearings but a grinder and a chisel will get them off
figured i could buy the bearings remove the old ones and take the axils into a shop to have them pressed
trying to save a buck
any advice would be much appreciated
Who is online
Users browsing this forum: No registered users and 33 guests