Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
GU running rough
GU running rough
I've got a 2005 GU 3.0 litre that at times is running rough at idle. it revs up fine and has just had major service. Any ideas what this could be?
Re: GU running rough
Take it back, if its just had a major service and is rooted, dont even look at it.tlc75v8 wrote:has just had major service.
Re: GU running rough
time bomb is almost out of time....tlc75v8 wrote:I've got a 2005 GU 3.0 litre that at times is running rough at idle. it revs up fine and has just had major service. Any ideas what this could be?
I was deadly serious! A mate took his 3L in for a service came out not running right, thought it will be something small i'll find as i go.tlc75v8 wrote:Good one dick headthehanko wrote:quickly so it blows up in their garage not yours.
he got far enough to blow up his engine and it cost him 10 grand!
You took a car with known problems in for a service and it came out not running correctly - take it back!
if you dont then be it on you IF something goes wrong. it may not, but thats a big gamble especially when its their responsibility to fix a mistake they have made.
but if you keep driving it anyway then its your responsibility.
or better than taking it to nissan specialists you could ask some guys to have a guess without seeing the vehicle on the net.
you recieved sound advice lashed out? wtf.
*there's a rock, drive over it :) there's a bigger rock, drive over it :twisted: there's an even bigger rock, oops broke it :oops: Upgrade broken bit :bad-words:
Goto *
Goto *
Contact NPC for a solid clutch conversion.tlc75v8 wrote:Just found out it is the duel mesh fly wheel, not meshing correctly and ''holding the engine back at idle''. Was planning on doing the clutch soon anyway.
Its DUAL MASS too. So if you have been told its not "massing" then someones spinning you shit.
Who is online
Users browsing this forum: No registered users and 0 guests