Well I finally replaced the rear axle with another std one on Sat morning, plus new dowels & studs. As soon as i drove out onto the rd noticed that the rear diff is not Unlocking at all (Richmond LockRight). Drove it 100miles to a 4wd park. Broke all the new studs and 1 dowel off after wheeling for about 4hrs.
What causes Lockrights to not unlock so I know what to look for when the time comes?
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
LockRight Not Unlocking
Moderators: toaddog, Elmo, DUDELUX
LockRight Not Unlocking
S.E.Qld Locals Crew.....
ok, a lockright never unlocks as such. What they do is allow one wheel to travel faster than the other but never slower.
So when you corner for example the outside wheel is allowed to go faster than the inside so it is the inside wheel that gets the drive.
If they do not do this it is ually do to bad install, incorrect springs or a bad unit. They are a pretty simple design and usually work well.
Be warned though under power they will hardly ever "unlock" due to their design. This is why they get bad torque steer.
So when you corner for example the outside wheel is allowed to go faster than the inside so it is the inside wheel that gets the drive.
If they do not do this it is ually do to bad install, incorrect springs or a bad unit. They are a pretty simple design and usually work well.
Be warned though under power they will hardly ever "unlock" due to their design. This is why they get bad torque steer.
ya supposed to re shim em after 12 months. it could be that the shims are to tight and not allowing it to unlock, mate had the same problem then reshimed it then all sweet, still goin today and its also a 60 series. 
.
double check all the clearances!!!!.
.double check all the clearances!!!!.
84 SINGLE CAB LUX , LOCKED, GEARED , CAGED, LONGED, 3RZ, 4 LINKED
92 1HDT 80, TWIN LOCKED, AS DAILY AND TOW BUS.
92 1HDT 80, TWIN LOCKED, AS DAILY AND TOW BUS.
Who is online
Users browsing this forum: No registered users and 21 guests