Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

smokey start

Tech Talk for Nissan owners.

Moderators: toaddog, V8Patrol

Post Reply
Posts: 6
Joined: Mon Sep 14, 2009 9:53 pm
Location: VIC

smokey start

Post by stickygq »

hey everyone, got a 98 model gq ute. i drowned it a few weeks ago and ever since, my glow plug light has been staying on and its also blowing abit of white smoke when i start it, but no smoke when im driving! been pretty hard to stat too! any ideas??????
Posts: 4330
Joined: Tue Jun 08, 2004 6:06 pm
Location: Central Victoria

Post by coxy321 »

My thoughts....
- bent rod (have you done a compression test?)
- Crook glow plugs, resulting in unburnt diesel (white smoke)
- Buggered injectors or pump (for your sake, hopefully not the pump).

Can you give any more detail about this "drowning" incident? Is it a 2.8, 4.2 or 4.2T?
Posts: 5060
Joined: Tue Apr 08, 2003 7:28 pm
Location: Narellan Vale, Sydney

Post by Screwy »

diesels are always very hard if not nearly impossible to start cold without glow plugs, so possible you could have a couple of them dead, or your glow plug timing unit / relay could of been shorted out resulting in poor glow of some description.......

screwy
TUFF TRUCK TEAM OPPOSITE LOCK Proudly Sponsored By:

Opposite Lock Narellan, Lightforce Australia, Offroad Systems, Judd Panels, Townsend Signs, RDG Engineering, Central Safety Workwear
Posts: 140
Joined: Sun May 18, 2008 4:24 pm
Location: bogged in a hole near you

Post by BeNoS »

when you say drowned do you mean engine swallowed water or just the ute got soaked?
if its swallowed water then id say chances are she is all over.
if its just taken a soaking id say the glow plug controller is full of water/buggered.
Posts: 248
Joined: Fri Jan 16, 2009 12:48 pm
Location: Sth Wst QLD

Post by 300WinMag »

Check your glow plug fuse first, then use a voltmetre to see if any current is getting to your glow plugs. If currnet at glow plugs, pull them out and resitance test each one, while your at it compression test the motor. If compression is down start saving $$$$$$$$$$$$$$.
Its all a process of elimination.
Posts: 2585
Joined: Fri Mar 28, 2008 4:45 pm
Location: SYDNEY

Post by thehanko »

id bet the glow plug timer/ controller is dead or a fuse gone. hence the light is showing, if it was just a dead glow plug i would not think the light would know aboutit, but check anyway.

once its at running temp does it feel ok? if so your a lucky bugger.
*there's a rock, drive over it :) there's a bigger rock, drive over it :twisted: there's an even bigger rock, oops broke it :oops: Upgrade broken bit :bad-words:
Goto *
Posts: 6
Joined: Mon Sep 14, 2009 9:53 pm
Location: VIC

smokey start

Post by stickygq »

its a 4.2 patrol. didnt suck any water into the motor has got a snorkel, but the inside of the car was soaked. the performance of the car hasnt changed at all. i pulled that little green box out from where the fuses are and it didnt look too bad!
Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests