Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

strange sound

General Tech Talk

Moderators: toaddog, TWISTY, V8Patrol, Moderators

Forum rules
Post Reply
Posts: 52
Joined: Mon Nov 02, 2009 11:44 am
Location: Deception Bay, QLD

strange sound

Post by stewy 60 series »

okay i have another question i recently cahnged the back diff center because i striped my gears and since i have put another one back in it it has been making a strange sound like something is tapping on something else as far as i can tell it is coming from the gearbox i think
Top
User avatar
RAY185
Resident Terrorist
Posts: 4278
Joined: Fri May 21, 2004 9:37 am
Location: Driving Barnsey's mum to bingo

Post by RAY185 »

Did you happen to seperate the transfer end of the tailshaft out of the slip joint while you had it off the car?
Top
Posts: 2809
Joined: Mon Jan 02, 2006 5:03 pm
Location: Lara Victoria

Post by Ruffy »

I think maybe now that you've changed the diff centre there is something tapping on something else.
[quote="Uhhohh"]As far as an indecent proposal goes, I'd accept nothing less than $100,000 to tolerate buggery. Any less and it's just not worth the psychological trauma. [/quote]
Top
Posts: 765
Joined: Fri Mar 12, 2010 7:28 pm
Location: Fixing something else the kids have broken

Post by BadMav »

Did you get all the bits of ground up diff gears out of the housing?
Don't take life too seriously...it isn't permanent.
Top
Posts: 52
Joined: Mon Nov 02, 2009 11:44 am
Location: Deception Bay, QLD

Post by stewy 60 series »

yea i cleaned it all out with degreaser and all the shavings were out and yes i did separate the tail shaft from the slip joint
Top
User avatar
RAY185
Resident Terrorist
Posts: 4278
Joined: Fri May 21, 2004 9:37 am
Location: Driving Barnsey's mum to bingo

Post by RAY185 »

Then you've probably put the shaft back together with the unis out of phase. Diff end uni and transfer end uni have to be aligned with each other as you sight down the length of the shaft. Even slightly out can cause vibrations/noises.
Top
Post Reply

Return to “General Tech”

Who is online

Users browsing this forum: No registered users and 162 guests