Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Transfer case gear fitting
Transfer case gear fitting
wendle how big a jodb was it to fit your low range gearset to your transfercase and did you replace all the bearings and seals .Also did you pull the case out or just the back of and do it under the vehicle if on the bench is it easy to remove the case.
yeah, it's not too bad a job. took me ages as I have no idea, but no too bad..
I did replace all the bearings and seals, only because I didn't know the history of the case that I bought. I know others who have just used all the original bearings and seals with no worries. you wouldn't be able to do it under the vehicle. It is easy to get the case out.
I did replace all the bearings and seals, only because I didn't know the history of the case that I bought. I know others who have just used all the original bearings and seals with no worries. you wouldn't be able to do it under the vehicle. It is easy to get the case out.
Who is online
Users browsing this forum: No registered users and 1 guest