Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

oil supply for turbo on 1hz???

Tech Talk for Cruiser owners.

Moderators: toaddog, Elmo, DUDELUX

Forum rules
Post Reply
Posts: 76
Joined: Fri Apr 09, 2010 2:31 pm
Location: melbourne

oil supply for turbo on 1hz???

Post by biegetroopy »

where should i pick up the oil to supply the turbo on a 1hz ?????
Top
Posts: 2347
Joined: Sat Jan 27, 2007 12:56 pm
Location: Perth

Post by Z()LTAN »

'T' in behind the oil pressure sender mate on the opposite side of the block
Locktup4x4.com.au - For all of your hardcore gear

Outlaws4x4.com
Top
Posts: 128
Joined: Mon Oct 23, 2006 5:29 pm
Location: Melbourne

Post by rezpkt »

As Z()LTAN said simply T off the oil pressure sender and run the braided oil line up and over the back of the engine. Use a piece of rope etc to dummy fit and measure the size needed then go to pirtek or enzed and get one made up.
Oil pressure sender has a 1/8 NPT thread.

Have fun.


Image
Team: Cause For Concern
http://www.offroad80s.com
Top
Posts: 76
Joined: Fri Apr 09, 2010 2:31 pm
Location: melbourne

Post by biegetroopy »

thanks for that!!and what about the water line??and zoltan i did get a 2876r after all
Top
Posts: 2347
Joined: Sat Jan 27, 2007 12:56 pm
Location: Perth

Post by Z()LTAN »

hehe u wont be displeased believe me!

Water lines you T into the heater hoses on each side of the heater core.
Locktup4x4.com.au - For all of your hardcore gear

Outlaws4x4.com
Top
Post Reply

Return to “Cruiser / Prado”

Who is online

Users browsing this forum: No registered users and 8 guests