Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

1997 disco sometimes won't start when hot

Tech Talk for Rover owners.

Moderator: Micka

Post Reply
Posts: 194
Joined: Sun May 11, 2008 12:30 am
Location: Manila, Philippines

1997 disco sometimes won't start when hot

Post by monmendoza »

Good morning,

I wonder if anyone has this problem with their disco. I have a 300tdi disco auto that runs very well but sometimes it won't start when hot. I have already replaced the starter motor with a brand new one but it seems the problem is still existent.

When it won't start, the motor does not turn over. Symptoms is very similar to a the transmission left at drive. but of course its in park.
The dashboard lights do not dim when you turn the starter key and you can't and feel the starter moving at all. If you wait for about 10 minutes
the engine will start one click as though nothing has happened.

BTW my unit does not have an ecu instead it has a manual injection pump.
any inputs would be greatly appreciated. thank you. :)
Posts: 37
Joined: Fri Jun 06, 2008 10:47 pm
Location: Sydney

Post by fe11xx »

You'll probably find you have excessive resistance in the starter solenoid circuit. Even though you have replaced the starter (this isn't the problem) the resistance will lie in either the wiring or the key barrel. Instead of tracing all the wiring and switches etc, you can relay the system so your existing solenoid power feed acts as the power for the relay coil. Then the pull in side of the solenoid will get a healthy 12-13v or so from the battery with little resistance.

The reason it does this when hot is that as everything heats up, resistance will increase. If there is already high resistance in the circuit, it simply becomes too much and you don't get anything (hence why the lights dont dim).

Hope this helps
Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests