Ive posted this querry in general tech under this link...
http://www.outerlimits4x4.com/PHP_Modul ... highlight=
With all the V8 conversions I have done I've always used the std nissan diesel 9 & 1/2" clutch pak and it has in the past stood up quite well...... That was untill I fitted the 350 Chev, now I've blown number 2 in as many weeks
So what I am thinking is......
The 10 & 1/2" Range Rover pressure plate....
The 275mm nissan TDI clutch plate from a 99 model....
has any-one got a RR pressure plate lying around that they could get some mesurements off of for me please ???
Kingy
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
RR experts
Moderator: Micka
God of Magnificant Ideas!
RR experts
[color=blue][size=150][b]And your cry-baby, whinyassed opinion would be.....? [/b][/size][/color]
Before i killed the LT77 in my RR after fitting the Holden engine.
I used the HSV clutch set up that came with the engine.
Clutch plate was the same spline.
so it all just fitted in.
regards
Michael.
I used the HSV clutch set up that came with the engine.
Clutch plate was the same spline.
so it all just fitted in.
regards
Michael.
Mitsubishi 2010 NT DID Pajero wagon, Factory rear diff lock, Dual batteries, ARB bar, winch, Mt ATZ 4 rib tyres.
1986 RR.
Custom suspension links etc.
HSV 215 engine.
4.3 diffs.
1986 RR.
Custom suspension links etc.
HSV 215 engine.
4.3 diffs.
God of Magnificant Ideas!
Thanks John, but I've got the pressure plate under control now, I needed the measurement of the "locating pin centres".
RR have a few different clutch paks on offer and I was trying for one that I could fit onto the holden/chev flywheel......
ended up with a 10 & 1/2" std RR pressure plate that suits the RR V8's
and a 265mm 99 model TDI Nissan clutch plate.
The 2 marry together very well, unfortunately the 275mm nissan clutch plate wouldnt clear the pressure plate by 2 mm
Thanks for your help guys
Kingy
RR have a few different clutch paks on offer and I was trying for one that I could fit onto the holden/chev flywheel......
ended up with a 10 & 1/2" std RR pressure plate that suits the RR V8's
and a 265mm 99 model TDI Nissan clutch plate.
The 2 marry together very well, unfortunately the 275mm nissan clutch plate wouldnt clear the pressure plate by 2 mm
Thanks for your help guys
Kingy
[color=blue][size=150][b]And your cry-baby, whinyassed opinion would be.....? [/b][/size][/color]
Who is online
Users browsing this forum: No registered users and 2 guests