Ok, well with the GQ diffs going into the Rangie, and seeing i'm sticking with the rangie transfer, the tailshaft angle for the rear may become a problem.
The thing will not be a daily driver but will have some decent power going thru it with the 350 chev, and some decent traction with 38" TSL's and lockers.
What I want to know is if you guys think the rangie shaft and uni's will stand up to it or should I be looking for, say, an F100 tailshft and cut it down.
The diff to pinon vertical angle won't be huge as it will only be 2-3" lift but there will also be the offset angle from D/S output from the transfer to centre pumpkin on the diff.
I think I would prefer to run REALLY BIG UNI"S rather than a double cardin as it will be eaiser and cheaper to repair and I feel more reliable over all. But I would love to hear your thoughts and comments.
Cheers
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Strenght of Rangie Tailshafts / Uni's
Moderator: Micka
Strenght of Rangie Tailshafts / Uni's
[quote="Wooders"]If ya want a 4x4 camry go ahead & buy a Patrol or Cruiser.[/quote]Rangie with 80s LC diffs, Isuzu 4bd1, Twin ARB lockers, 8000lb Hi mount warn, 315x75x16 Procomp XTerrains
A double carden will vibrate in that application cause to use a double carden the single uni joint needs to be straight. Normally people put a double at the transfer end and then point the pinion at the transfer so the lower single joint is straight. You carnt do this.
Best to just run two singles.
Sam
Best to just run two singles.
Sam
Strange Rover wrote:A double carden will vibrate in that application cause to use a double carden the single uni joint needs to be straight. Normally people put a double at the transfer end and then point the pinion at the transfer so the lower single joint is straight. You carnt do this.
Best to just run two singles.
Sam
Do you think the rangie ones will be big/strong enough or should I look at bigger uni's?
[quote="Wooders"]If ya want a 4x4 camry go ahead & buy a Patrol or Cruiser.[/quote]Rangie with 80s LC diffs, Isuzu 4bd1, Twin ARB lockers, 8000lb Hi mount warn, 315x75x16 Procomp XTerrains
Maggot4x4 wrote:Strange Rover wrote:A double carden will vibrate in that application cause to use a double carden the single uni joint needs to be straight. Normally people put a double at the transfer end and then point the pinion at the transfer so the lower single joint is straight. You carnt do this.
Best to just run two singles.
Sam
Do you think the rangie ones will be big/strong enough or should I look at bigger uni's?
they should be fine!
Sam runs them in the mogrover
hands and mums dont count!!!
Who is online
Users browsing this forum: No registered users and 3 guests