I've got a 04 gu leaf/coil ute and recently i've been getting a brake failure but its only when im 4wdriving on a steep hill. Basically when the car is on the hill an i reach for the anchors, the pedal goes spungy and straight to the floor. If i pump them quickly i will get very minimal pressure back but its not until the trucks on the flat again that the brakes fully return.
Ive bled them, there is no air in the lines.
Any ideas? any help would be greatly appreciated.
Thanks
Jake.
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Brake Failure on GU
Re: Brake Failure on GU
Maybe its not generating enough vacuum?
Maybe your vac booster is leaking?
Maybe your vac booster is leaking?
hands and mums dont count!!!
Re: Brake Failure on GU
Have you checked the front wheel bearings for excessive play - the discs will push the pads back into the caliper thus making you pump the pedal to get the brake pad back on the disc , if it was the booster the pedal would be rock hard but not going to the floor .. good luck
Re: Brake Failure on GU
You could also check the brake proportioning valve above the rear diff
Who is online
Users browsing this forum: No registered users and 126 guests