I have just noticed that the front output shaft from the transfer case has a leak in that area. At the moment, I have the front shaft removed so its easy to see. The leak seems to be dribbling down from the front area near output shaft.
Is there a quick fix with gaskets/seals that may fix this problem? Im assuming that the output shaft seal has gone. If this is the case, is this a complete transfer case removal, or are the cases that are removed from that area to repair seal etc.
Im no mechanic so please excuse my lack of technical expertise or any reminense of sense in regards to my descriptions lol....
Jarrod
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
LN106 Hilux Transfer case
Moderators: toaddog, Elmo, DUDELUX
LN106 Hilux Transfer case
2008 Nissan Patrol Wagon ST 3.0TD
1994 LN106 Singlecab 2.8
1994 LN106 Singlecab 2.8
Re: LN106 Hilux Transfer case
listen fella its as easy as 123 abc
seriously now, stick it in 4wd, hand brake on, in the middle of the flange on the front of the transfer. find a way to undoo that big nut, then the flange should come off, and then there is a seal in there, replace it and put back togeather. make sure everything is clean when you put the new seal and that in. repco orsimilar will get a seal for you. this instruction may not be 100 percent accurate, but i know that 90% of it is. there may be a clip or something behind the flange, i cant remember but i dont think there is
seriously now, stick it in 4wd, hand brake on, in the middle of the flange on the front of the transfer. find a way to undoo that big nut, then the flange should come off, and then there is a seal in there, replace it and put back togeather. make sure everything is clean when you put the new seal and that in. repco orsimilar will get a seal for you. this instruction may not be 100 percent accurate, but i know that 90% of it is. there may be a clip or something behind the flange, i cant remember but i dont think there is
Many thanks to Buds Customs, for all their ongoing support
Call Buddy on 0417 708 598 for all your custom and off the shelf parts, fabrication, and installation
Call Buddy on 0417 708 598 for all your custom and off the shelf parts, fabrication, and installation
Re: LN106 Hilux Transfer case
Ta mate, was hoping it was a straight forward job like you described. Will visit my friendly Repco haunt and get seal.
btw... nice truck in your sig pic. Tis what Im planning on building my lux into.
Jarrod
btw... nice truck in your sig pic. Tis what Im planning on building my lux into.
Jarrod
2008 Nissan Patrol Wagon ST 3.0TD
1994 LN106 Singlecab 2.8
1994 LN106 Singlecab 2.8
Re: LN106 Hilux Transfer case
You might want to lubricate the seals sealing surface before installing the drive flange.. This will prevent dry startup of the seal and prevent damage.. You might need to drop the oil from the transfer before pulling the flange too?
Who is online
Users browsing this forum: No registered users and 0 guests