Quick question about radiators for my ln106 hilux. I have the factory 2.8 radiator that is leaking slightly from what looks to be a previous repair on teh top end tank.
I managed to get hold of a radiator from a 2.4 Turbo when I bought the Turbo kit from a guy wrecking an older (early 80's) Hilux.
The radiators look virtually identical except that on the 2.4 the inlet/outlet on the bottom tank is on the same side as the inlet/outlet on the top whereas on the 2.8 they are on opposite ends.
If I can get hoses to connect them up will these two radiators be interchangable or is the position of the inlet/outlet important for cooling purposes?
I can take a photo if what I'm saying isn't clear.
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
2.4D radiator in a 2.8D Hilux
Moderators: toaddog, Elmo, DUDELUX
Re: 2.4D radiator in a 2.8D Hilux
Unless it's a 2 pass rad (goes to 1 side in the top 1/2 and comes back in the lower 1/2 of the rad), ideally you want to make the water in the rad go completely from one corner to the other to cool it the best it can.
If it's a 3 or 4 core, fits and cools your engine properly, it's all good
If it's a 3 or 4 core, fits and cools your engine properly, it's all good
91' Hilux Surf with the usual mods & a few different ones ....
Coil SAS by www.budscustoms.com.au
Coil SAS by www.budscustoms.com.au
Who is online
Users browsing this forum: No registered users and 6 guests