Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Help with my Flat Battery (I think its catching)
Moderator: -Scott-
Help with my Flat Battery (I think its catching)
Ok, I have wired up my dual batteries and smart charge solenoid as per instructions. 1st battery set up as normal, with +ve running to solenoid. Cable then goes from solenoid to second battery in tray that is earthed to a bolt under the body.
Now I have had this set up for a week but only driven maybe twice in the week, drives of about 30 minutes.
Now went to start the lux up tonight for the first time in 2 days and it didnt have enough charge to turn over. Lights would come on, glow plugs would heat just not enough to kick over. 2nd battery is still working fine as I ran the compressor off it to check. So it seems my main battery isnt being charged anymore, i dunno?
So any ideas on what could be wrong?
When i wire it up, I can put an overide switch on the solenoid so that I can start the lux of the 2nd battery.
Now I have had this set up for a week but only driven maybe twice in the week, drives of about 30 minutes.
Now went to start the lux up tonight for the first time in 2 days and it didnt have enough charge to turn over. Lights would come on, glow plugs would heat just not enough to kick over. 2nd battery is still working fine as I ran the compressor off it to check. So it seems my main battery isnt being charged anymore, i dunno?
So any ideas on what could be wrong?
When i wire it up, I can put an overide switch on the solenoid so that I can start the lux of the 2nd battery.
MY JEEP BUILD
v840 wrote: [Not a shot at Tonka] It's like saying, hell I've got two nuts, I may as well cut one of them off for the hell of it. I ain't using it.[/NAS@T] It's ridiculous!
Just measured the batteries.
Main start battery is 12.15V
Second Battery is 12.8V
I just dont have enough juice to start the lux. the solenoid has the provision to start off the second battery with the aid of a dash mounted switch, i just havent wired it up yet......
Could something be draining my main battery? Have I wired something wrong?
Only things on the main battery are winch and starter.
Both batteries are 600CC heavy duty 4x4 batteries (not deep cycles etc)
Main start battery is 12.15V
Second Battery is 12.8V
I just dont have enough juice to start the lux. the solenoid has the provision to start off the second battery with the aid of a dash mounted switch, i just havent wired it up yet......
Could something be draining my main battery? Have I wired something wrong?
Only things on the main battery are winch and starter.
Both batteries are 600CC heavy duty 4x4 batteries (not deep cycles etc)
MY JEEP BUILD
v840 wrote: [Not a shot at Tonka] It's like saying, hell I've got two nuts, I may as well cut one of them off for the hell of it. I ain't using it.[/NAS@T] It's ridiculous!
So should I test my Alternator output?
And if so.............How?
How do i test for leaks?
Anything?
And if so.............How?
How do i test for leaks?
Anything?
MY JEEP BUILD
v840 wrote: [Not a shot at Tonka] It's like saying, hell I've got two nuts, I may as well cut one of them off for the hell of it. I ain't using it.[/NAS@T] It's ridiculous!
stop parking near my GQ flat batteries are contageous
to check the alternator is workin all the dude did on mine was put a multi meter on the batt terminals with it runnin, should be 13.9 volts (or close to) that means its charging from what i was told?? id go start mine now and double check but its got no fuel tank in it
to check the alternator is workin all the dude did on mine was put a multi meter on the batt terminals with it runnin, should be 13.9 volts (or close to) that means its charging from what i was told?? id go start mine now and double check but its got no fuel tank in it
Leprecaun wrote:I did mine a few moments ago, its a 750cc and it was hitting 14, so I'd say doing it that way would tell you if its charging or not. Otherwise try disconnecting the dual battery and solenoid and see if it starts, you may have a faulty solenoid.
wot he said
normally if recently modify something and then doesnt work as should do, return system to standard and then slowly re-modify untill find faul. btw, those battery voltages dont seem to low to me
Cant start the truck though.
MY JEEP BUILD
v840 wrote: [Not a shot at Tonka] It's like saying, hell I've got two nuts, I may as well cut one of them off for the hell of it. I ain't using it.[/NAS@T] It's ridiculous!
are they both starter batteries? either way should still be able to start car from starter battery or deep cycle
wire it up straight to each battery to try to start, if wont work that way chuck on battery chargher for a while then try again. once you have car running check voltage at terminals, then you'll know if alternator works.
if you can rule out alternator, then time to investigate wiring of solenoid or actual solenoid itself. what does smart charge solenoid mean anyway
wire it up straight to each battery to try to start, if wont work that way chuck on battery chargher for a while then try again. once you have car running check voltage at terminals, then you'll know if alternator works.
if you can rule out alternator, then time to investigate wiring of solenoid or actual solenoid itself. what does smart charge solenoid mean anyway
Means it will only charge main battery and once charged, solenoid will allow charging of second battery.
MY JEEP BUILD
v840 wrote: [Not a shot at Tonka] It's like saying, hell I've got two nuts, I may as well cut one of them off for the hell of it. I ain't using it.[/NAS@T] It's ridiculous!
Battery
Maybe the starter battery has died as well. I just found out one of mine has carked it. Shows 12.8 volts after being charged on battery charger. When cranking it drops to 8.1 volt. Cant hurt to test it and see if there is a big voltage drop when cranking. If there is, it may be a shagged battery
Ok. Jump started the car to get it going. Starting battery came in at 13.8 volts and the second battery around the same.
When I turned the truck off the second battery measured in at 12.8V while the main battery dropped off to 12.31V While I held the meter on it, it dropped quite quickly from around 12.79 to 21.31V.
So the main battery which only has winch and starter seems to be draining somewhere..........
When I turned the truck off the second battery measured in at 12.8V while the main battery dropped off to 12.31V While I held the meter on it, it dropped quite quickly from around 12.79 to 21.31V.
So the main battery which only has winch and starter seems to be draining somewhere..........
MY JEEP BUILD
v840 wrote: [Not a shot at Tonka] It's like saying, hell I've got two nuts, I may as well cut one of them off for the hell of it. I ain't using it.[/NAS@T] It's ridiculous!
Havent disconnected anything as I have been away for 4 days and just jump started the truck tonight. Will see what happens in the morning.
If it were the winch thats draining the battery, what would actually be draining it so much? Ie: what would cause the power leak?
If it were the winch thats draining the battery, what would actually be draining it so much? Ie: what would cause the power leak?
MY JEEP BUILD
v840 wrote: [Not a shot at Tonka] It's like saying, hell I've got two nuts, I may as well cut one of them off for the hell of it. I ain't using it.[/NAS@T] It's ridiculous!
might pay to take your starting battery to a battery place, they can test them by applying a load and measuring the voltage, they can then tell you how many amps the battery can put out.
I had a 670amp battery which measured around 12v but would only just turn the car over, they tested it and it was only good for about 250amps, was stuffed
At least this way you'll eliminate the battery from the eqaution, they shouldn't charge either as they might make a sale
I had a 670amp battery which measured around 12v but would only just turn the car over, they tested it and it was only good for about 250amps, was stuffed
At least this way you'll eliminate the battery from the eqaution, they shouldn't charge either as they might make a sale
There are no stupid questions, but there are a LOT of inquisitive idiots
A fully charged 12V lead acid battery should be between 12.6 and 12.9V with no load. The second battery sounds good.
Most charging systems typically charge a little higher than 13.8V, but 13.8V should still give you a full charge if given long enough.
The battery voltage dropping back to 12.3 when you stop the engine is simply indicating the battery isn't fully charged. The next test should be to disconnect it. If the terminal voltage rises at all (or you get a spark as you pull the connector off) then yes, something is draining the battery.
A battery dropping to 8V while cranking isn't unusual. A starter motor draws huge amounts of current (like a winch can) and the internal resistance of the battery creates a significant voltage drop. I'd get the battery professionally load tested before I throw it out - and don't tell the tester what you're thinking, or he might confirm your suspicions for you so you buy a new battery.
Good luck,
Scott
Most charging systems typically charge a little higher than 13.8V, but 13.8V should still give you a full charge if given long enough.
The battery voltage dropping back to 12.3 when you stop the engine is simply indicating the battery isn't fully charged. The next test should be to disconnect it. If the terminal voltage rises at all (or you get a spark as you pull the connector off) then yes, something is draining the battery.
A battery dropping to 8V while cranking isn't unusual. A starter motor draws huge amounts of current (like a winch can) and the internal resistance of the battery creates a significant voltage drop. I'd get the battery professionally load tested before I throw it out - and don't tell the tester what you're thinking, or he might confirm your suspicions for you so you buy a new battery.
Good luck,
Scott
Who is online
Users browsing this forum: No registered users and 1 guest