Ok i have a td42, going into a gu it is fully rebiult, ballanced, blue printed, 3 way coated pistons and ported head. Its built to alot higher spec's then i needed to, but figured while its apart and i have the time nd spare coin id take it abit futher incase it ever see's dirt (tow car).
So same idea with the turbo would like it to be capable of 30psi stable if i ever take it up there. Will this turbo allow for this?
Specifications:
Water & Oil-cooled,
External wastegated.
Compressor Cover 0.5A/R
Compressor Cover inlet: 2.5"
Compressor Cover outlet 2"
Compressor Trim: 48
Inducer 53mm, exducer 76.5mm
Exhaust side:
T3 size flange.
0.58AR turbine housing.
Turbine wheel Exducer 48mm, Inducer 64.5mm
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Turbo aplication?
Turbo aplication?
Blown ls1 GQ winch truck. and GU tow car / daily
Re: Turbo aplication?
Any one. Come on i know theres some gurus out there?
Blown ls1 GQ winch truck. and GU tow car / daily
Re: Turbo aplication?
Need to see the comp flow map to determine where its at efficiency wise at 30psi.
Apart from that it shouldnt have any problems making 30psi. But by the looks of the wheel sizes it will be a little lazy to come onto boost.
Apart from that it shouldnt have any problems making 30psi. But by the looks of the wheel sizes it will be a little lazy to come onto boost.
Who is online
Users browsing this forum: No registered users and 1 guest