Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Fuel Gauge

Tech Talk for Cruiser owners.

Moderators: toaddog, Elmo, DUDELUX

Post Reply
Posts: 23
Joined: Fri Jan 29, 2010 9:30 pm
Location: Brisbane

Fuel Gauge

Post by mqharko »

The sub tank fuel gauge on my 1999 toyota landcruiser ute hzj79r doesnt work at all. What can i do to fix this?
Posts: 19
Joined: Mon Oct 12, 2009 11:05 am
Location: Melbourne

Re: Fuel Gauge

Post by pipebender »

if you short the sender wire does the guage work? it should slowly move to fuel if the wiring and guage are working correctly. ( Ignition on if it normally reads empty with ignition off). If the guage doesnt move most likely faulty sender.
Posts: 23
Joined: Fri Jan 29, 2010 9:30 pm
Location: Brisbane

Re: Fuel Gauge

Post by mqharko »

How do I short the sender wire? What do I do If it's a faulty sender?
Posts: 19
Joined: Mon Oct 12, 2009 11:05 am
Location: Melbourne

Re: Fuel Gauge

Post by pipebender »

disconnect the wiring at the sender and earth out the wire or loop the terminals together at the connector just make a short jump wire, ( looping the wires may not give you a result if the earth wire is your problem best to short to earth ) you may have to wait 20- 30 secs for the guage to move. Good luck
Posts: 184
Joined: Mon May 21, 2007 10:15 am
Location: floatin around

Re: Fuel Gauge

Post by 302 cruiser »

if you short the sender wire does the guage work? it should slowly move to fuel if the wiring and guage are working correctly. ( Ignition on if it normally reads empty with ignition off). If the guage doesnt move most likely faulty sender
what? dont you mean if the guage does move you have a faulty sender?

i would short between the 2 terminals of the wires going to the sender first then if the gauge dosent work then i would short to ground
Posts: 19
Joined: Mon Oct 12, 2009 11:05 am
Location: Melbourne

Re: Fuel Gauge

Post by pipebender »

you are correct, my mistake, the guage or wiring would most likely be faulty if the needle didnt move. If it did the sender would be the issue. Cheers
Posts: 23
Joined: Fri Jan 29, 2010 9:30 pm
Location: Brisbane

Re: Fuel Gauge

Post by mqharko »

Thanks for the replys. Where would I find the sender?
Posts: 184
Joined: Mon May 21, 2007 10:15 am
Location: floatin around

Re: Fuel Gauge

Post by 302 cruiser »

its the bit in the tank the wires for it go from the back chassis cross member forward to the tank
Last edited by 302 cruiser on Mon May 16, 2011 6:01 pm, edited 1 time in total.
Posts: 23
Joined: Fri Jan 29, 2010 9:30 pm
Location: Brisbane

Re: Fuel Gauge

Post by mqharko »

No where under the bonnet do i find the sender so i can test whether or not its faulty.
Posts: 184
Joined: Mon May 21, 2007 10:15 am
Location: floatin around

Re: Fuel Gauge

Post by 302 cruiser »

yea its in the tank
Posts: 23
Joined: Fri Jan 29, 2010 9:30 pm
Location: Brisbane

Re: Fuel Gauge

Post by mqharko »

thanks for that mate.
Posts: 23
Joined: Fri Jan 29, 2010 9:30 pm
Location: Brisbane

Re: Fuel Gauge

Post by mqharko »

i found that right before the rear sub tank, theres a connector join. The connector on the side running to the battery is a 3 way connector with 3 cables going into it. The connector running from the fuel tank is a 3 way connector with only 2 cables running out of it. Am i missing an earth from the fuel tank side?? I looked where the cables go into the tank and only 2 go in, so its not like theres a broken cable somewhere.
Posts: 184
Joined: Mon May 21, 2007 10:15 am
Location: floatin around

Re: Fuel Gauge

Post by 302 cruiser »

no there is only 2 wires to the rear tank the 3rd one would be if it had a fuel light on the rear tank and they dont, did you bridge the wires and see if the gauge moved?
Post Reply

Who is online

Users browsing this forum: No registered users and 82 guests