Has anyone got a comparison of sizes of conrods for the TB 42, 45 and 48 engines.
I know the 42 ones are beefier than the 45 ones but I'm after pin to pin sizing and a comparison of small end and big end sizing to see if there is any difference between all three engines.
The info is wanted for a guy I know who is looking into getting H beam rods built to suit at the moment TB45 but wondering what differences (if any) there are particularly with the TB48.
Regards Andrew.
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Conrod sizes, TB 42, 45, 48
Conrod sizes, TB 42, 45, 48
We are Tig welders, gravity doesn't worry us.
[img]http://www.studmonkeyracing.com/forums/smilies/weld.gif[/img]
[img]http://www.studmonkeyracing.com/forums/smilies/weld.gif[/img]
Re: Conrod sizes, TB 42, 45, 48
Crower make a billet I beam rod to suit the tb42/tb45. 42/45's have the same stroke, and a rod length of 6.552".
Carillo make a H beam rod to suit the tb48 that is 6.437" in length.
You might want to check with those manufacturers as to the big end bore and width and the pin size.
Carillo make a H beam rod to suit the tb48 that is 6.437" in length.
You might want to check with those manufacturers as to the big end bore and width and the pin size.
Who is online
Users browsing this forum: No registered users and 4 guests