There was a PTO advertised in the local paper over here for $350. Is that a reasonable price??
Are they hard to install??
Any help would be great.
MArc
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
PTO MQ PATROL
I was found a unit in a spares place and they wanted $550 for it. Be careful as to which box it is to adapt with, as the 4spd and 5spd use diffrent length shafts.
Eventually i didn't go PTO anyway on the MQ as the oil breather defeated the purpose of the idea. I.e. the fact that anything i would be needing to winch up would already be causing a loss of oil from this line due to the angle, having my car more on this slope whilst the engine still running... sounds like disaster to me!
Eventually i didn't go PTO anyway on the MQ as the oil breather defeated the purpose of the idea. I.e. the fact that anything i would be needing to winch up would already be causing a loss of oil from this line due to the angle, having my car more on this slope whilst the engine still running... sounds like disaster to me!
It depends what is included? Is it just the pto drive that goes on the back of the t/c? pretty sure they aren't available new anymore. Ive got the same set up on my mq tray, it runs to a powauto t8 winch, parts are available for the winch itself through david brown powauto hydraulics outlets.
As far as installation goes you will either need to modify a standard bar or get an arb commercial bar to fit the winch, the drive shaft is pretty simple it runs up the passenger side of the box through the hole in the front of the chassis.
As far as installation goes you will either need to modify a standard bar or get an arb commercial bar to fit the winch, the drive shaft is pretty simple it runs up the passenger side of the box through the hole in the front of the chassis.
There are no stupid questions, but there are a LOT of inquisitive idiots
Who is online
Users browsing this forum: No registered users and 0 guests