Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

About HD-E distributor

Tech Talk for Ford, Mazda, Daihatsu & Makes that currently dont have a home.

Moderator: Tiny

Forum rules
Post Reply
Posts: 5
Joined: Sat Apr 10, 2004 12:17 am

About HD-E distributor

Post by nozik »

Hi, all!
I live in the Minsk of Belorussia & have a Feroza HardTop (F300) 1991
My question: What are the dimensions of rubber “O”-ring at distributor?
Thanks!
Top
Posts: 4760
Joined: Mon Dec 30, 2002 6:04 am
Location: Adelaide

Contact:
Contact murcod

Post by murcod »

Hi, are you talking about the O ring that seals the distributor shaft into the engine's head (ie the oil seal)? Or the rubber gasket that goes between the distributor's plastic cap and alloy body?
David
Top
Posts: 5
Joined: Sat Apr 10, 2004 12:17 am

re

Post by nozik »

Exactly - "O" ring that seals the distributor shaft into the engine's head
Last edited by nozik on Wed Apr 14, 2004 1:39 am, edited 1 time in total.
Top
Posts: 5
Joined: Sat Apr 10, 2004 12:17 am

oops...

Post by nozik »

Image insert problem...
Top
Posts: 4760
Joined: Mon Dec 30, 2002 6:04 am
Location: Adelaide

Contact:
Contact murcod

Post by murcod »

:D Try removing the spaces in the image name.

I'll grab my vernier callipers later tomorrow (today? it's 1am here....) and measure the o ring on my spare distributor.
David
Top
Posts: 5
Joined: Sat Apr 10, 2004 12:17 am

Re

Post by nozik »

Thank you, David! I will wait!
Top
Posts: 4760
Joined: Mon Dec 30, 2002 6:04 am
Location: Adelaide

Contact:
Contact murcod

Post by murcod »

OK, bearing in mind that the o ring on mine is used and flattened out a bit:

The outside diameter is 37.0mm, the diameter of the rubber forming the o ring is ~ 3.5- 4mm. It's hard to give accurate measurements due to the o ring being deformed.

The actual distributor shaft measures 36.0mm max and 30.0mm where the o ring sits- so the above figures for the o ring should be right.
David
Top
Posts: 5
Joined: Sat Apr 10, 2004 12:17 am

Thank you!

Post by nozik »

Thank you, David - HEARTLY!
Top
Post Reply

Return to “Ford / Mazda / Daihatsu / Homeless”

Who is online

Users browsing this forum: No registered users and 0 guests