Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

HELP!! TD42 loss of power above 2k revs

Tech Talk for Nissan owners.

Moderators: toaddog, V8Patrol

Post Reply
Posts: 13
Joined: Fri Nov 27, 2009 1:31 pm
Location: NORTH QUEENSLAND

HELP!! TD42 loss of power above 2k revs

Post by farmerbrown34 »

Hi all.

I’ve recently lost a lot of power in my 2000 GU patrol. I was driving along the highway at about 110kmh when I realised that’s as fast as it would go. Slowly the more I drove the slower it got, maxing out at about 95kmh after about 50km of driving. I pulled up and changed the fuel filter thinking it was clogged....no change. It would rev to about 2400revs max in natural. I then turned the engine off and on repeatedly, each time the engine would rev a little higher and finally I got it to rev to about 4400. It seemed to be fixed however still not as much power as usual.

Then took off for home again and got another 50km down the highway and the same thing, maxing out at about 90kmh.

I took the new fuel filter off when I got home and it was still perfectly clean inside.

Does this sound like air getting into my fuel lines somewhere? Is there anyway to test if is air getting in? I was thinking of replacing the fuel line between the fuel filter and injector pump with clear hose so I can see any bubbles?

Cheers,
Matthew
Posts: 306
Joined: Fri Oct 10, 2008 4:02 pm
Location: Hobart, Tasmania

Re: HELP!! TD42 loss of power above 2k revs

Post by tas80 »

Replacing the fuel line with clear hose to check for air bubbles as you've suggested is a good start.

Not sure if you know about it but there is a small gauze filter below the banjo bolt on the injector pump that can get gummed up, remove the banjo bolt then use a piece of tie wire with a very small hook bent into the end of it and fish the filter out, clean with contact cleaner or similar.

I'm assuming you're talking about a TD42?

Image
100 Series Ute: Chopped, Locked and Rolled
GU Ute: Lotsa Good Stuff!
RIP UTED100, Hello GU Ute
Posts: 13
Joined: Fri Nov 27, 2009 1:31 pm
Location: NORTH QUEENSLAND

Re: HELP!! TD42 loss of power above 2k revs

Post by farmerbrown34 »

Ok Cheers ill give that a go this arvo.

Yeah its a TD42 turbo.

Cheers,
matthew
Posts: 3189
Joined: Thu Mar 04, 2004 1:11 pm
Location: Jimboomba

Re: HELP!! TD42 loss of power above 2k revs

Post by BIG GQ »

Air filter?
Cheers
Linc

[quote="chimpboy"]Punctuation is the difference between 'I helped my Uncle Jack off his horse' and 'I helped my uncle jack off his horse.'[/quote]
Post Reply

Who is online

Users browsing this forum: No registered users and 43 guests