Does anybody know if adapting a H55 gearbox to 1VD engine is possible?
1VD bellhousing looks totally different from the outside, and doesn’t appear to be an easy task.
Is the bolt pattern of a 1VD the similar to the 1Hx series, enabling the use of a 1Hx bellhousing? Starter motor positions could be an issue here.
I presume the 1VD uses the 300mm clutch with 14 spline shaft from the 1HD-x (to mate with H151) making the use of the Isuzu (or custom) clutch combination necessary
Could a H55 bolt to a 1VD Bellhousing given the correct clutch setup? The 1VD bellhousing appears to be quite long.
I’m doubtful of all of the above, but am throwing it out there anyway.
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
1VD-FTV adaptability
Moderators: toaddog, Elmo, DUDELUX
1VD-FTV adaptability
Last edited by KingOffTheRoad on Mon Apr 02, 2012 12:16 pm, edited 1 time in total.
HJ47 Troopy - Rear Air locker, 3" lift, 33 claws, Marks transfer gears, 60 Pwr Steer.
Re: 1VD-FTE adaptability
Probably possible, but why would you? Box wouldnt last to well. Much better off using the box it comes with, H151 or H150 cant remember which. Same box used in 80 series and many 70 series.
The Silver Bullet - BJ74
Where the actions at Ontrack 4wd Club
http://www.ontrack4wdclub.com/
[url]http://www.cams.com.au/[/url]
Where the actions at Ontrack 4wd Club
http://www.ontrack4wdclub.com/
[url]http://www.cams.com.au/[/url]
Re: 1VD-FTE adaptability
Depends what it is going into you would also need to use the 7X's transfer box as the input/output shafts are different. If it were a conversion i would use the engine, gearbox and transfer out of the 7X series
if ya gona rev it, Chev it
Who is online
Users browsing this forum: No registered users and 10 guests