hi guys i have a 1990 3F carby 80 series and looking at putting a 1HZ in to it as i can get one cheap so have a few Q's about the swap.
my 80 runs a H150F gearbox and from what i can tell the 1HZ 80 runs the same gearbox different bellhousing and clutch
1HZ clutch is
Size, Spline OD & No. of Teeth 275 x 29.7 x 21
Flywheel Profile +0.5mm
3F clutch is
Size, Spline OD & No. of Teeth 275 x 27.9 x 10
Flywheel Profile +0.5mm
so i can use a 3F clutch on the 1hz but is the 3F H150F the same as the 1HZ H150F (spline length)
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
3F to 1HZ swap
Moderators: toaddog, Elmo, DUDELUX
3F to 1HZ swap
Tires are like boobs, they always look big until you have played with them for a while, then you just want a bigger set
Re: 3F to 1HZ swap
so can anyone help?
if some one has a 1hz gearbox (H150F) out can they measure the input shaft and the bellhousing
if some one has a 1hz gearbox (H150F) out can they measure the input shaft and the bellhousing
Tires are like boobs, they always look big until you have played with them for a while, then you just want a bigger set
Who is online
Users browsing this forum: No registered users and 0 guests