Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

2005 Pajero Exceed Diesel

Tech Talk for Mitsubishi owners.

Moderator: -Scott-

Post Reply
Posts: 19
Joined: Thu Dec 19, 2002 6:39 am
Location: Caboolture

2005 Pajero Exceed Diesel

Post by Cruiser »

Hi I am having trouble with the fuel gauge in the Pajero at 1/4 mark the tank seems empty. Does anyone know where I can access the sending unit at the tank.
Keep your roof facing skyward
Posts: 14209
Joined: Sun Jan 11, 2004 11:36 am
Location: Adelaide

Re: 2005 Pajero Exceed Diesel

Post by -Scott- »

Cruiser wrote:Hi I am having trouble with the fuel gauge in the Pajero at 1/4 mark the tank seems empty. Does anyone know where I can access the sending unit at the tank.
I don't know about the Gen 3, but Gen2s have a removable panel in the floor in the load area, under the carpet, towards the forward side of the fuel tank. I believe it's primarily for access to the fuel pump, but I think the gauge can be reached here too.
Posts: 511
Joined: Tue Jan 15, 2008 1:33 pm
Location: Cooma NSW

Re: 2005 Pajero Exceed Diesel

Post by date »

On a Gen 2, the fuel pump and the fuel gauge sender come out the same hole. I cannot see MM changing their design for this.
Posts: 17
Joined: Sun May 21, 2006 1:08 pm
Location: Wagga Wagga

Re: 2005 Pajero Exceed Diesel

Post by psproule »

In a Gen 3 pajero the pump, filter and gauge is installed under the right hand rear passenger seat (2nd row - not 3rd). Flip the seat over and you will see a plate with 4 bolts. Remove that and there will be another plate in the cavity below. Remove that plate and you will see the top of the sender / pump. You might need to hose the mud off it before you remove it. You will need to de-pressurise the lines to remove them - pull the electrical connector to the pump and crank the motor for a bit. THen they will come apart.

Pat
Patrick : NP DID GLX Pajero, Smart Bar, 2" Lift with Bilsteins & Pedders, LRA tank, Shower, Inverter, GME UHF, 1 wife, 3 kids and a dog!
Post Reply

Who is online

Users browsing this forum: No registered users and 28 guests