Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
no low range 80 dx box help!!
Moderators: toaddog, Elmo, DUDELUX
no low range 80 dx box help!!
Have a manual dx transfercase in my 80 series was playing on the weekend in lowrange put it in highrange for a bit than tried to go back to low and just wouldn't do anything oil is full no grinding noises at all anyone got any ideas ive spoken to John at Jmac and its got him stumped till he has a look at it
Re: no low range 80 dx box help!!
My understanding is that near all transfer cases run off two cables. These select between 2wd and 4wd and then lo/hi. You have to look at the cables to see if there is a issue there. Sure to be a pain in the ass unless you have midget hands.
Other than that it may be a internal selector arm or whatever they use.
Never looked at a 80 case or pulled a case apart, so i could be way off.
Other than that it may be a internal selector arm or whatever they use.
Never looked at a 80 case or pulled a case apart, so i could be way off.
Re: no low range 80 dx box help!!
Do you have neutral??
There is a ball looking joint under there someware that gets full of crap or a pin falls out or something.
I know its vague but its on the transfer box selector system,
I got stuck in neutral long time ago took it to someone who knew what they were doing and were to look and they belted ball joint on fence to get of of crap and all was good ever after. this was on a '47 probabaly similar
Is simple and cheap to fix . carton type of job.
There is a ball looking joint under there someware that gets full of crap or a pin falls out or something.
I know its vague but its on the transfer box selector system,
I got stuck in neutral long time ago took it to someone who knew what they were doing and were to look and they belted ball joint on fence to get of of crap and all was good ever after. this was on a '47 probabaly similar
Is simple and cheap to fix . carton type of job.
Re: no low range 80 dx box help!!
Well we pulled it apart and I'd stripped the low range gear someone had had it apartin its past life and wasn't lined up properly 
Who is online
Users browsing this forum: No registered users and 85 guests