Purposely bent rear control arms

[V.W.Dave]

I came across a fairly built up rover today It was on sals diffs and a good 4" or more lift.( I wish I had my phone to take a picture) I had a quick look under it and the control arms on the rear diff were bent into a S shape now I understand why it was done. To make the bolt end of the arm go through the busha on the chassis strate so they arnt maxing out the travel at normal ride hight to allow more down travel.

Have any of you dont this? Does anyone have any pictures of it? If you have done it did you have any issues?

[PacMan]

RTE in USA sells them.
http://www.rte-fab.com/products?page=sh ... gory_id=54

[V.W.Dave]

Thank you very much that is exactly what I was looking for

[GRIMACE]

Dave I have the RTE rear links on my POS, they are great.
I also have the rear upper shock mounts and a couple of pairs of front radius arms are floating around in other peoples rigs all over the place.
I like the gear cause it's a bit booty fab, but have to be honest and say the last lot of gear I got was getting a bit too booty fab.

Just hope your stuff arrives... I had missing items in both my orders with them. Then about 6 months later one of the missing items from my original order arrived...

[V.W.Dave]

Grim.

I will message you I want ot know more about these items