http://www.ebay.com.au/itm/Tapered-Ream ... =RTM756594" onclick="window.open(this.href);return false;
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Tapered reamer for ball joints/tie rod.
Moderators: toaddog, TWISTY, V8Patrol, Moderators
Tapered reamer for ball joints/tie rod.
Looking for one of these. Not keen on paying $100+ to do 2 knuckles and then having one sit in the draw for the next 20yrs. Chasing one to suit GM 1 ton tie rods ( 1 1/2 inch per foot or 7.13 degree's )
http://www.ebay.com.au/itm/Tapered-Ream ... =RTM756594" onclick="window.open(this.href);return false;
http://www.ebay.com.au/itm/Tapered-Ream ... =RTM756594" onclick="window.open(this.href);return false;
Re: Tapered reamer for ball joints/tie rod.
Is it for a street car?
If not just drill the arm out and run a HT bolt with heim joints
If not just drill the arm out and run a HT bolt with heim joints
Buds Customs : Street, Track & Trail - Parts & Fabrication - Nissan, Toyota, Custom D60 gear
http://www.facebook.com/budscustoms
http://www.facebook.com/budscustoms
Re: Tapered reamer for ball joints/tie rod.
WICKED wrote:Is it for a street car?
If not just drill the arm out and run a HT bolt with heim joints
Its for a tie rod flip on a CJ7 Jeep (1978)
Re: Tapered reamer for ball joints/tie rod.
Low range Offroad sell them
www.energizedracing.com
Support from:
Locktup 4x4
Arb Newcastle
Genr8 LED lighting
Yukon Gear & Axle
Overkill Engineering
Ruffstuff Specialties
Support from:
Locktup 4x4
Arb Newcastle
Genr8 LED lighting
Yukon Gear & Axle
Overkill Engineering
Ruffstuff Specialties
Re: Tapered reamer for ball joints/tie rod.
i have one i chucked in my low range order for fj80 tierod ends if you are flexable on your tierod choice..
82 MQ SD33T, 5 speed, 4.6 diffs, 50mm spring, 40mm body, front extened 50mm, 35' trapdors (awsum) just lovin getin out there
Who is online
Users browsing this forum: No registered users and 3 guests